Delphi TD1074W Suspension Stabilizer Bar Bushing Kit - Rear

Delphi Rear Stabilizer Bar Bushing Kit TD1074W

Delphi TD1074W is a rear suspension stabilizer bar bushing kit built for OE-style replacement on select Volvo applications. It uses rubber construction and standard replacement dimensions to support proper sway bar location and consistent rear suspension response.

Key Features

• Rubber bushing material with black finish
• Standard replacement grade for rear suspension service
• Inside diameter: 16.0 mm (0.63 in.)
• Outside diameter: 28.0 mm (1.102 in.)
• Designed for vehicles with a 16 mm rear bar diameter
• Compatible with Volvo S40 and Volvo V40 rear applications

Application Details

Compatible with 2000-2003 Volvo S40, rear, with 16mm bar diameter, and 2000-2004 Volvo V40, rear, with 16mm bar diameter. Delphi TD1074W is engineered using dimensional and material analysis to match OE fit and support proper stabilizer bar positioning in the rear suspension.

This part cross-references Mevotech Supreme MS108205 for the same application.

What It Helps Address

• Rear sway bar movement caused by worn bushings
• Clunking or rattling from the rear suspension area
• Excessive play at the stabilizer bar mounting point
• Reduced suspension control from deteriorated rubber bushings
• Fitment issues when replacing a 16 mm rear stabilizer bar bushing on Volvo S40 or V40 models

Installation Notes

Verify rear stabilizer bar diameter before ordering. This bushing kit is specified for 16 mm bar diameter applications on the listed Volvo S40 and Volvo V40 models. Inspect the stabilizer bar and mounting surfaces for wear or corrosion before installation to help ensure proper seating and long-term service.

Quality Assurance

Delphi applies OE-focused testing and material validation to its aftermarket steering and suspension components. This part is evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and for corrosion exposure through 720 hours of salt spray testing.