Delphi TD1115W Suspension Control Arm Bushing - Rear Lower Forward

Delphi Rear Lower Forward Control Arm Bushing

Delphi TD1115W is a standard replacement suspension control arm bushing for the rear lower forward position on select Land Rover Range Rover applications. Built with rubber and press-fit mounting, it is sized for OE-style fitment and consistent suspension articulation.

Key Features

• Rubber suspension control arm bushing for rear lower forward placement
• Press-fit mounting type for direct replacement service
• Standard replacement grade for Land Rover Range Rover suspension repair
• Dimensions: 0.555 in inside diameter, 2.055 in outside diameter, 2.913 in height
• Metric dimensions: 14.1 mm ID, 52.2 mm OD, 74.0 mm height
• Wall thickness: 0.75 in / 19.1 mm
• Delphi TD1115W is engineered using dimensional and material analysis for OE-to-aftermarket compatibility

Detailed Description

Delphi TD1115W is a suspension control arm bushing designed for the rear lower forward position on 2003-2012 Land Rover Range Rover and 2014-2015 Land Rover Range Rover models. The rubber construction helps restore the control arm’s mounting interface while maintaining the compliance needed for suspension movement. Delphi applies OE-focused engineering practices to its aftermarket steering and suspension portfolio, including dimensional and material analysis to match the original part as closely as possible. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 2014-2015 Land Rover Range Rover, rear lower forward.
• Fits 2003-2012 Land Rover Range Rover, rear lower forward.

Common Repair Uses

• Restores worn rear lower forward control arm mounting points
• Addresses suspension looseness or excess movement at the bushing location
• Helps reduce clunking or knocking from deteriorated rubber bushings
• Supports more stable rear suspension geometry on Land Rover Range Rover models
• Replaces cracked, hardened, or deformed control arm bushing material

Installation Notes and Tips

Delphi TD1115W uses a press-fit design, so proper bushing removal and installation tools are required. Inspect the control arm and surrounding hardware for wear before installation, and verify the rear lower forward position against the vehicle’s suspension layout before ordering. Confirm the part number TD1115W and match the dimensions to the original bushing when servicing Land Rover Range Rover suspension components.

Quality Assurance

Delphi tests this OE-style replacement bushing across extreme temperature ranges below -40 degrees C and above 120 degrees C, and subjects it to 720 hours of salt spray exposure. These validation steps support durability for demanding suspension service conditions on Land Rover Range Rover applications.