Delphi TD1117W Suspension Control Arm Bushing - Rear Lower Rearward

Delphi TD1117W Rear Lower Rearward Bushing

The Delphi TD1117W is a suspension control arm bushing built for the rear lower rearward position on select Land Rover applications. It uses a rubber construction and press-fit mounting to support OE-style suspension geometry and consistent control arm movement.

Key Features

• Rubber suspension control arm bushing for standard replacement service
• Press-fit mounting type for the rear lower rearward position
• Dimensions: 16.1 mm inside diameter, 46.7 mm outside diameter, 81.0 mm height
• Wall thickness: 15.3 mm
• Engineered with Delphi OE dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation

Detailed Description

Delphi TD1117W is a suspension control arm bushing for the rear lower rearward location, made for Land Rover LR3, LR4, and Range Rover Sport applications. The rubber construction helps maintain suspension articulation while supporting the control arm at the correct mounting point. Delphi applies OE-focused engineering and material analysis to help match aftermarket fit and function to the original part. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 2010-2016 Land Rover LR4, rear lower rearward.
• Fits 2006-2015 Land Rover Range Rover Sport, rear lower rearward.
• Fits 2005-2009 Land Rover LR3, rear lower rearward.

Common Repair Uses

• Restoring rear suspension control arm stability
• Reducing looseness or play at the rear lower rearward mounting point
• Addressing worn rubber that can affect alignment consistency
• Replacing a deteriorated bushing on Land Rover LR3, LR4, or Range Rover Sport models
• Improving suspension response after bushing wear or cracking

Installation Notes

Press-fit installation is required, so the old bushing must be removed and the control arm bore inspected before installation. Confirm the rear lower rearward position and verify dimensions against the original part before pressing in Delphi TD1117W. Proper suspension torque procedures should be followed at ride height after installation.

Quality Assurance

Delphi uses OE-based engineering, dimensional checks, and material analysis to support fit and performance. The part is validated through extreme temperature exposure and extended salt spray testing to help confirm durability in demanding suspension service.