Delphi TD1124W Suspension Control Arm Bushing - Rear Upper Outer

Delphi Rear Upper Outer Control Arm Bushing

The Delphi TD1124W is a standard replacement suspension control arm bushing for the rear upper outer position. Built with a rubber-steel construction, it is made for BMW suspension service where precise fit and stable control arm mounting matter.

Delphi applies OE-focused dimensional and material analysis to help match aftermarket fit and function to the original part. The TD1124W is a press-fit bushing with a gray finish and dimensions of 49.5 mm length, 49.5 mm height, 11.4 mm wall thickness, and 12.2 mm inside diameter.

Key Features

• Part number: TD1124W
• Suspension control arm bushing for the rear upper outer position
• Rubber-steel construction for OE-style mounting support
• Press-fit design for direct suspension service
• Standard replacement grade
• Gray finish
• No mounting hardware included

Application Details

Compatible with BMW rear suspension service on select 2006-2015 models, including BMW 320i, BMW X1, BMW 335i, BMW 335d, BMW 335xi, BMW 325i, BMW 325xi, and BMW 330i in the rear upper outer position. If you are replacing a worn BMW control arm bushing, Delphi TD1124W provides the correct fitment profile for the listed applications.

This part cross-references MOOG Chassis Products K200070 for the same application.

What This Part Helps Address

• Rear suspension looseness or play at the control arm mounting point
• Clunking or knocking from worn bushings
• Uneven tire wear related to suspension movement
• Imprecise rear suspension response on BMW 320i, X1, 335i, and related models
• Degraded ride control caused by cracked or separated rubber-steel bushings

Installation Notes

TD1124W is a press-fit bushing, so proper removal and installation tools are recommended. Inspect the control arm and surrounding suspension components before installation, and verify the rear upper outer position on the vehicle before pressing the new bushing into place. Because mounting hardware is not included, reuse or replacement decisions should be made during service based on the condition of the existing components.

Quality Assurance

Delphi validates its steering and suspension parts through OE-oriented testing, including exposure to extreme temperatures and extended salt-spray conditions. The brand also uses dimensional and material analysis to support consistent aftermarket fitment for BMW suspension applications.