Delphi TD1137W Suspension Control Arm Bushing - Front Lower Inner Forward

OE-Style Front Lower Inner Forward Bushing

Delphi TD1137W is a suspension control arm bushing built for the front lower inner forward position. It uses a rubber-steel construction and press-fit mounting to match the OE-style layout used on select Acura TSX and Honda Accord applications.

Delphi applies dimensional and material analysis to support fitment accuracy, and this bushing is tested across extreme temperature and corrosion conditions for demanding undercar use. The TD1137W is a standard replacement part for restoring suspension joint support and control arm isolation.

Key Features

• Suspension control arm bushing for the front lower inner forward position
• Rubber-steel construction for controlled compliance and durability
• Press-fit mounting type for OE-style installation
• Standard replacement grade for direct service use
• Gray finish
• Delphi TD1137W part number for catalog matching and cross-reference lookup

Detailed Description

Delphi TD1137W is engineered for vehicles that use a front lower inner forward control arm bushing, including 2004-2008 Acura TSX and 2003-2007 Honda Accord. The bushing measures 60.0 mm in length and height, with a 14.2 mm inside diameter, 30.1 mm wall thickness, and 2.921 in outside diameter. Its rubber-steel design helps maintain suspension geometry while isolating road vibration through the control arm mounting point. This part cross-references MOOG Chassis Products K200238 for the same application.

Common Repair Symptoms

• Clunking or knocking from the front suspension
• Excessive control arm movement under braking or cornering
• Uneven tire wear caused by worn suspension bushings
• Loose or unstable steering feel on Acura TSX and Honda Accord models
• Visible cracking, separation, or deterioration at the control arm bushing

Installation Notes and Tips

Fits 2004-2008 Acura TSX, front lower inner forward. Fits 2003-2007 Honda Accord, front lower inner forward. This is a press-fit bushing, so proper removal and installation tools are recommended to avoid damage to the control arm or new bushing. Inspect the surrounding control arm, mounting surfaces, and alignment components before installation, and verify the position matches the front lower inner forward location before pressing the part into place.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to temperature extremes below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. That testing, combined with dimensional and material analysis, supports OE-style fit and corrosion resistance for the TD1137W.