Delphi TD1147W Suspension Control Arm Bushing - Rear Upper Outer

Delphi Rear Upper Outer Control Arm Bushing

Delphi TD1147W is a suspension control arm bushing built for the rear upper outer position on select Honda applications. It uses a rubber-to-metal construction with a press-fit mounting design to support precise suspension location and consistent ride control.

Key Features

• Rubber-to-metal construction for suspension isolation and control
• Press-fit mounting type for OE-style installation
• Standard replacement grade for direct service use
• Black finish
• Dimensions: 1.566 in length, 1.23 in outside diameter, 0.398 in inside diameter
• Position: rear upper outer
• Delphi TD1147W engineered with OE dimensional and material analysis for fit consistency

Detailed Description

Delphi TD1147W suspension control arm bushing is designed for the rear upper outer location and is built to match the dimensional and material requirements of the original application. Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, with testing that includes extreme temperature exposure and salt-spray durability evaluation. This helps support long-term performance in demanding road conditions. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Compatible With 1997-2001 Honda CR-V, rear upper outer; 1996-2000 Honda Civic, rear upper outer; and 1995-1997 Honda Civic del Sol, rear upper outer. Delphi TD1147W is a direct-fit service part for drivers replacing worn suspension bushings on these Honda models.

What It Helps Address

• Excessive suspension movement at the rear upper outer control arm location
• Clunking or knocking from worn rubber bushings
• Imprecise rear suspension geometry caused by bushing wear
• Road vibration transferred through deteriorated suspension mounts
• Uneven handling response from aged control arm bushings

Installation Notes and Tips

Press-fit installation is required, so the old bushing must be removed and the control arm bore inspected before installation. Confirm the rear upper outer position and verify dimensions against the removed part before pressing in Delphi TD1147W. Proper alignment service after suspension work is recommended to restore correct geometry.

Quality Assurance

Delphi subjects its OE-style parts to temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. The brand also uses dimensional and material analysis to improve OE and aftermarket part compatibility.