Delphi TD1201W Suspension Control Arm Bushing - Front Lower Inner Rearward

OE-Style Front Lower Control Arm Bushing

The Delphi TD1201W is a suspension control arm bushing built for the front lower inner rearward position on select Mitsubishi Eclipse models. It combines rubber and steel construction with OE-focused dimensional and material analysis for a precise replacement fit.

Compatible with 1995-1999 Mitsubishi Eclipse, front lower inner rearward, this Delphi bushing is a standard replacement for restoring suspension joint support and control arm isolation.

Key Features

• Rubber-steel construction for strength and vibration isolation
• Standard replacement design for OE-style service fit
• Pressed and bolt-on mounting type
• Gray finish
• Inside diameter: 0.492 in
• Length: 5.213 in (132.4 mm)
• Height: 2.221 in (56.4 mm)
• Distance between mounting holes: 4.154 in (105.5 mm)
• Position: front lower inner rearward

Detailed Description

Delphi TD1201W is engineered as a suspension control arm bushing for the front lower inner rearward location. Delphi applies OE-level dimensional and material analysis to support proper compatibility between the original part and the aftermarket replacement, while the rubber-steel design helps maintain suspension articulation and reduce unwanted movement at the control arm mounting point. This part cross-references MOOG Chassis Products K80828 for the same application.

Fits 1995-1999 Mitsubishi Eclipse, front lower inner rearward. The TD1201W is a direct-fit style replacement for service work on the front suspension of the Mitsubishi Eclipse, helping restore the control arm’s mounting integrity and alignment stability.

What It Helps Address

• Excessive play at the front lower control arm mounting point
• Clunking or knocking from worn suspension bushings
• Uneven suspension response caused by deteriorated rubber
• Loss of control arm isolation from road vibration
• Fitment issues when replacing a worn OE-style bushing on a Mitsubishi Eclipse

Installation Notes and Tips

This bushing uses a pressed and bolt-on mounting type, so installation may require suspension disassembly and proper pressing tools depending on the vehicle and service procedure. Verify the front lower inner rearward position, confirm dimensions against the removed part, and inspect the control arm and surrounding hardware for wear before installation. Professional alignment is recommended after suspension service.

Quality Assurance

Delphi tests its OE-style steering and suspension components under extreme temperature and corrosion conditions, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. The TD1201W is built using Delphi’s OE-focused engineering approach for consistent aftermarket replacement quality.