Delphi TD1213W Suspension Control Arm Bushing - Front

Front Suspension Control Arm Bushing for BMW

Delphi TD1213W is a standard replacement front suspension control arm bushing built for BMW applications that require a 24mm fitment. It is engineered with Delphi OE-focused dimensional and material analysis to help maintain proper suspension geometry and consistent control arm support.

Fits 1995-2000 BMW 320i, 325i, 325is, 328i, 328is, 323i, 323is, and Z3 front applications listed below. This part cross-references BMW 31 35 1 090 263 for the same application.

Key Features

• Delphi TD1213W suspension control arm bushing
• Standard replacement grade for front suspension service
• 24mm fitment for listed BMW front applications
• OE-focused dimensional and material analysis for proper compatibility
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation

Detailed Description

Delphi TD1213W is a front suspension control arm bushing for select BMW models, including BMW Z3, 323i, 323is, 328i, 328is, 320i, 325i, and 325is applications with 24mm specifications. Delphi applies OE engineering knowledge from its steering and safety portfolio to the aftermarket replacement part, with attention to fit, material selection, and dimensional accuracy. The result is a direct-fit suspension bushing for front-end service where control arm support and suspension alignment are critical.

What It Helps Address

• Front suspension looseness or excess play
• Clunking or knocking from worn control arm bushings
• Uneven tire wear related to suspension movement
• Steering response that feels less precise
• Vibration or instability from deteriorated bushing material

Installation Notes and Tips

• Confirm the vehicle uses the listed front 24mm application before ordering.
• Check whether the vehicle is equipped with Sport Suspension or M Sport suspension, since some fitments exclude those configurations.
• Inspect related suspension components for wear before installation.
• Have front-end alignment checked after suspension service.

Quality Assurance

Delphi validates this bushing through temperature cycling and salt-spray exposure testing to support durability in demanding conditions. OE-based dimensional and material analysis is used to help ensure proper fitment for the listed BMW front applications.