Delphi TD1275W Suspension Stabilizer Bar Bushing Kit - Front To Frame

Delphi TD1275W Front Stabilizer Bar Bushing Kit

Delphi TD1275W is a front stabilizer bar bushing kit built as a standard replacement for OE-style suspension service. It uses rubber construction and is engineered for front-to-frame mounting on select Nissan applications, including Altima and Maxima models.

Key Features

• Rubber bushing material for suspension isolation and bar support
• Black finish with standard replacement grade
• Front to frame position for stabilizer bar mounting
• Inside diameter: 22.0 mm (0.866 in)
• Outside diameter: 1.24 in; width: 41.5 mm; height: 9.75 mm
• OE-focused dimensional and material analysis for fit consistency
• Delphi TD1275W cross-references MOOG Chassis Products K200327 for the same application

Detailed Description

Delphi TD1275W is a suspension stabilizer bar bushing kit for front-to-frame service on select Nissan vehicles. It is specified for 2002-2006 Nissan Altima, front to frame; 2004-2006 Nissan Maxima, front to frame; and 2007-2008 Nissan Maxima, front. Delphi applies OE-level engineering practices to its aftermarket steering and suspension portfolio, including dimensional and material analysis to support proper part matching. The rubber construction and standard replacement grade make this part a direct service option for restoring stabilizer bar support on Nissan Altima and Nissan Maxima applications.

This part cross-references MOOG Chassis Products K200327 for the same application.

What It Helps Address

• Front stabilizer bar movement at the frame mount
• Suspension noise from worn or hardened bushings
• Excess play in the sway bar mounting point
• Reduced front-end stability caused by deteriorated rubber bushings
• Fitment issues when replacing OE-style front-to-frame bushings on Nissan Altima and Maxima

Installation Notes and Tips

Verify the stabilizer bar diameter and mounting location before installation. This part is specified for front-to-frame use on the listed Nissan Altima and Nissan Maxima applications, so confirm the vehicle year and position against the fitment data for Delphi TD1275W. Inspect the sway bar, frame mount, and surrounding suspension components for wear before reassembly.

Quality Assurance

Delphi subjects its OE-focused suspension components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. These validation steps support durability expectations for everyday suspension service on the listed Nissan applications.