Delphi TD1322W Suspension Stabilizer Bar Bushing Kit - Rear

Delphi Rear Stabilizer Bar Bushing Kit TD1322W

Delphi TD1322W is a rear suspension stabilizer bar bushing kit built as a standard replacement for select Hyundai Accent applications. It uses rubber construction and OE-focused dimensional analysis to support proper fit and consistent suspension bar support on the rear axle.

Key Features

• Rubber bushing construction with black finish
• Rear position application
• Inside diameter: 0.57 in. (14.6 mm)
• Width: 1.45 in. (36.9 mm)
• Height: 1.325 in. (33.7 mm)
• Standard replacement grade for suspension service
• No grease fitting included
• No mounting hardware included

Product Details

Delphi applies OE engineering experience to its aftermarket steering and suspension portfolio, and TD1322W reflects that approach with material and dimensional checks for fit consistency. The rubber bushing is specified for rear stabilizer bar service on 1997 Hyundai Accent and 1998-2006 Hyundai Accent models, helping maintain the bar’s location and reduce unwanted movement at the rear suspension. This part cross-references Beck/Arnley 101-6248 for the same application.

Vehicle Fitment

• Fits 1998-2006 Hyundai Accent, rear.
• Fits 1997 Hyundai Accent, rear, from 11/11/1996.

What It Helps Address

• Rear stabilizer bar looseness
• Bushing wear from age and road exposure
• Clunking or rattling from the rear suspension area
• Excessive sway bar movement at the rear axle
• Loss of consistent bar support on Hyundai Accent rear suspension systems

Installation Notes

Inspect the stabilizer bar, brackets, and surrounding hardware before installation. Clean the mounting surfaces and verify the bushing dimensions match the original part before assembly. Because mounting hardware is not included, reuse or replace related components as needed during service. TD1322W is a direct-fit rear stabilizer bar bushing kit for the listed Hyundai Accent applications.

Quality Assurance

Delphi tests suspension components for OE-level performance across extreme temperature ranges below -40 degrees C and above 120 degrees C, and subjects parts to extended salt-spray exposure for corrosion resistance evaluation. The brand also uses dimensional and material analysis to support OE-to-aftermarket compatibility. Part number TD1322W is built to those standards for rear suspension service.