Delphi TD1462W Suspension Stabilizer Bar Bushing Kit - Rear To Frame

Delphi Rear Stabilizer Bar Bushing Kit TD1462W

Delphi TD1462W is a rear to frame suspension stabilizer bar bushing kit built as a standard replacement for select BMW applications. It uses rubber-to-metal construction and OE-focused dimensional analysis to support proper fit and consistent suspension control.

Key Features

• Rubber to metal construction for stable bar mounting
• Black finish
• Inside diameter: 13.5 mm (0.531 in.)
• Width: 48.5 mm (1.909 in.)
• Height: 46.0 mm (1.811 in.)
• Standard replacement, regular grade
• Rear to frame position

Application Details

Compatible with BMW rear stabilizer bar service on 2006-2010 BMW 550i, rear to frame; 2006-2010 BMW 650i, rear to frame; 2008 BMW 535i, rear to frame with Sport Handling Package; and 2008-2010 BMW 528i, rear to frame with Sport Handling Package. This part number, TD1462W, is also referenced for the same application under cross-reference numbers such as Monroe Shocks & Struts 172286 and 182286.

What It Helps Address

• Rear sway bar movement caused by worn bushings
• Clunking or rattling from the rear suspension area
• Excessive play at the stabilizer bar mounting point
• Reduced suspension response during cornering
• Noise from deteriorated rubber bushings at the frame mount

Installation Notes

Install at the rear to frame stabilizer bar location and verify the inside diameter, width, and height against the original bushing before service. Confirm vehicle configuration, especially Sport Handling Package applications on the BMW 528i and BMW 535i, before ordering TD1462W.

Quality Assurance

Delphi applies OE-level dimensional and material analysis to aftermarket steering and suspension parts. This bushing kit is tested across extreme temperatures below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability in harsh conditions.