Delphi TD1619W Suspension Control Arm Bushing - Front Right Rearward

OE-Style Front Right Rearward Bushing

Delphi TD1619W is a suspension control arm bushing built for OE-style replacement on select Subaru applications. It uses rubber construction and bolt-on mounting to support the front right rearward position with dimensions matched for proper fit and alignment.

Fits 2004-2007 Subaru Impreza, front right rearward. Fits 1995-2004 Subaru Legacy, front right lower rearward. Fits 1995-2003 Subaru Impreza, front right lower rearward. Fits 2000-2003 Subaru Outback, front right lower rearward.

• Rubber construction for suspension isolation and control arm support
• Bolt-on mounting type for direct replacement service
• Standard replacement grade for OE-style service work
• Dimensions: 0.795 in inside diameter, 2.047 in outside diameter, 2.008 in height
• Built for the front right rearward or front right lower rearward control arm position, depending on application

Fitment and Application Details

This Delphi control arm bushing is specified for Subaru Impreza, Legacy, and Outback front suspension applications where the rearward control arm bushing location is used. Delphi TD1619W is listed for 2004-2007 Subaru Impreza front right rearward, plus 1995-2004 Subaru Legacy, 1995-2003 Subaru Impreza, and 2000-2003 Subaru Outback in the front right lower rearward position. This part cross-references Dorman Premium CAS721002PR for the same application.

Common Problems This Part Addresses

• Excessive front suspension movement at the control arm pivot
• Clunking or knocking from worn rubber bushings
• Steering looseness caused by deteriorated bushing material
• Uneven tire wear related to control arm deflection
• Alignment instability after bushing wear or cracking

Installation Notes and Tips

Confirm the vehicle position before ordering, since this part is listed for front right rearward and front right lower rearward applications. Compare the original bushing dimensions and mounting style to the OE part before installation. Proper suspension inspection and alignment checks after replacement help verify that the control arm is seated correctly and the front suspension geometry is restored.

Quality Assurance

Delphi applies OE-focused dimensional and material analysis to support aftermarket fitment, and its steering and suspension parts are tested across extreme temperature and salt-spray exposure conditions to evaluate durability in demanding environments.