Delphi TD1634W Suspension Stabilizer Bar Bushing Kit - Rear To Frame

OE-Style Rear Stabilizer Bar Bushing Kit

Delphi TD1634W is a suspension stabilizer bar bushing kit built for rear-to-frame mounting on select BMW applications. It uses EPDM rubber construction and OE-based dimensional analysis to support proper fit and consistent sway bar control.

Key Features

• EPDM rubber material for suspension use
• Black finish
• Inside diameter: 0.48 in. / 12.2 mm
• Outside diameter: 1.693 in. / 43.0 mm
• Width and height: 1.81 in. / 46.0 mm
• Regular grade, standard replacement part
• Rear to frame position
• Grease fitting not included
• Mounting hardware not included

Application Details

Delphi TD1634W is engineered for BMW rear stabilizer bar service where the bushing mounts to the frame. It is a direct replacement choice for BMW 328i, BMW 335i, BMW 528i, and related xDrive and xi models listed in the fitment data, including applications such as 2007-2011 BMW 328i, rear to frame, and 2008-2010 BMW 528i, rear to frame, except Sport Chassis. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. The part number TD1634W is also useful when searching for a rear sway bar bushing kit for BMW suspension repair.

Common Problems This Part Can Address

• Rear sway bar movement caused by worn bushings
• Clunking or knocking from the rear suspension area
• Excessive play at the stabilizer bar frame mount
• Reduced bar control from cracked or hardened rubber
• Uneven suspension response on BMW rear-to-frame applications

Installation Notes and Tips

Confirm sway bar diameter and mounting location before installation, especially on applications with notes such as 2012 BMW 328i with 13 mm diameter sway bar or 2008 BMW 528i except Sport Chassis. Inspect the stabilizer bar and frame contact surfaces for wear, corrosion, or deformation before installing the new bushings. TD1634W is a rear to frame bushing kit, so correct placement is important for proper suspension operation.

Quality Assurance

Delphi applies OE-focused testing and material analysis to its aftermarket steering and suspension portfolio. These bushings are evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and for extended salt-spray exposure to help verify durability in demanding conditions.