Delphi TD1655W Suspension Control Arm Bushing - Front Left Lower Rearward, Front Lower Rearward or Front Right Lower Rearward

Delphi TD1655W Control Arm Bushing

The Delphi TD1655W is a suspension control arm bushing built for OE-style replacement on select Land Rover Range Rover applications. It uses rubber construction and press-fit mounting to support front suspension service where precise bushing dimensions matter.

• Rubber construction for standard replacement service
• Press-fit mounting type for OE-style installation
• Inside diameter: 14.2 mm (0.559 in)
• Outside diameter: 47.1 mm (1.854 in)
• Wall thickness: 16.5 mm (0.648 in)
• Length: 73.91 mm
• Height: 74.0 mm (2.913 in)
• Position-specific fitment for front lower rearward control arm locations

Fitment and Application

Compatible with 2013-2015 Land Rover Range Rover, front lower rearward; 2016 Land Rover Range Rover, front left lower rearward; and 2017 Land Rover Range Rover, front right lower rearward. This Delphi TD1655W control arm bushing is also referenced by part numbers such as Beck/Arnley 102-8025 and Dorman OE Solutions 520-474 for the same application.

Detailed Description

Delphi applies OE-focused dimensional and material analysis to this suspension bushing so the aftermarket part matches the intended fit and function of the original component as closely as possible. The rubber design and press-fit configuration make the TD1655W a direct-service option for front suspension repair on Land Rover Range Rover models, especially where worn bushing material can affect alignment stability and suspension response. If you are sourcing a Delphi TD1655W for a Land Rover Range Rover front suspension repair, verify the exact position before ordering.

Common Issues This Part Can Address

• Clunking or knocking from the front suspension
• Excessive control arm movement at the bushing point
• Uneven tire wear related to suspension looseness
• Steering wander or reduced front-end stability
• Visible cracking, splitting, or deterioration of the original rubber bushing

Installation Notes and Tips

Press-fit installation requires proper suspension service tools and accurate positioning in the control arm. Confirm the vehicle year, model, and exact front left or front right lower rearward location before installation. Inspect the control arm and surrounding hardware for wear or damage before pressing in the new bushing.

Quality Assurance

Delphi tests this OE-style suspension bushing across extreme temperature ranges below -40 degrees C and above 120 degrees C, and exposes parts to 720 hours of salt spray to evaluate durability. The TD1655W is backed by Delphi’s OE engineering approach for aftermarket steering and suspension replacement.