Delphi TD1705W Suspension Control Arm Bushing - Front Lower Forward

Delphi TD1705W Front Lower Forward Bushing

Delphi TD1705W is a suspension control arm bushing for the front lower forward position on select Hyundai Santa Fe applications. Built with a rubber-steel construction, it is made for OE-style replacement where dimensional accuracy and material consistency matter.

For Hyundai Santa Fe front lower forward service, this Delphi bushing is engineered around OE fit and material analysis to help maintain proper suspension geometry and control arm support. The TD1705W is a standard replacement part for 2002-2006 Hyundai Santa Fe models listed below.

Key Features

• Part number: TD1705W
• Suspension control arm bushing for the front lower forward position
• Rubber-steel construction for strength and compliance
• Pressed + bolt-on mounting type
• Gray and black finish
• Standard replacement grade
• Dimensions: 139.5 mm length, 30.5 mm outside diameter, 12.5 mm inside diameter
• Designed using OE dimensional and material analysis for fit consistency

Detailed Description

Delphi TD1705W is a front lower forward suspension control arm bushing built for OE-style service on the Hyundai Santa Fe. Delphi applies OE-focused engineering and testing to its aftermarket steering and suspension portfolio, including exposure to extreme temperatures and salt spray testing to evaluate durability in demanding conditions. The result is a replacement bushing designed around accurate dimensions, material compatibility, and dependable suspension support. This part cross-references Beck/Arnley 101-6201 for the same application.

Compatible With 2002 Hyundai Santa Fe, front lower forward; 2003-2005 Hyundai Santa Fe, front lower forward; and 2006 Hyundai Santa Fe, front lower forward to 02/15/2006. Use Delphi TD1705W when replacing a worn front lower forward control arm bushing on the Hyundai Santa Fe and restoring proper suspension interface at the control arm mount.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive control arm movement at the mounting point
• Uneven tire wear caused by worn suspension bushings
• Loose or imprecise front-end feel
• Cracked, hardened, or deteriorated original bushing material

Installation Notes and Tips

This bushing uses a pressed + bolt-on mounting type and does not include mounting hardware. Verify the front lower forward position and confirm the vehicle build date for 2006 Hyundai Santa Fe applications, since fitment is limited to vehicles built to 02/15/2006. Compare the original bushing dimensions and mounting points before installation to ensure proper alignment.

Quality Assurance

Delphi uses OE-based dimensional and material analysis for aftermarket fitment and subjects parts to extreme temperature and corrosion testing, including temperatures below -40 degrees C, above 120 degrees C, and 720 hours of salt spray. These validation steps support consistent replacement quality for Hyundai Santa Fe suspension service.