Delphi TD1745W Suspension Control Arm Bushing - Front Lower Rearward

OE-Style Front Lower Rearward Bushing

Delphi TD1745W is a standard replacement suspension control arm bushing for the front lower rearward position. It is built for direct-fit service on select Kia Sorento, Hyundai Santa Fe, and Hyundai Veracruz applications, with OE-focused dimensional and material analysis for proper alignment and fit.

Delphi applies OE safety technology to its aftermarket steering and suspension portfolio, with testing that includes extreme temperature exposure and salt-spray durability checks. That approach helps support consistent performance in demanding road conditions.

Key Features

• Standard replacement suspension control arm bushing
• Front lower rearward position
• OE-based dimensional and material analysis for fit compatibility
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation
• Direct replacement for part number TD1745W

Vehicle Fitment

• Fits 2011-2013 Kia Sorento, front lower rearward.
• Fits 2009 Kia Sorento, front lower rearward.
• Fits 2007-2012 Hyundai Santa Fe, front lower rearward.
• Fits 2012 Hyundai Santa Fe, front lower rearward, to 07/31/2012.
• Fits 2007-2012 Hyundai Veracruz, front lower rearward.

This part cross-references OE number 54550-2P000 for the same application.

What It Helps Correct

• Excessive play in the front lower control arm mounting point
• Clunking or knocking from worn suspension bushings
• Steering looseness caused by deteriorated bushing material
• Uneven tire wear related to suspension movement
• Road vibration transferred through the front suspension

Installation Notes

Verify the vehicle’s build date and suspension position before ordering, especially for 2012 Hyundai Santa Fe models with the 07/31/2012 cutoff. Inspect the control arm and surrounding hardware for wear or damage during service, and confirm the replacement bushing matches the front lower rearward location on the vehicle.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for this suspension bushing, including dimensional and material checks plus environmental testing for heat, cold, and corrosion exposure. Part number TD1745W is built as a standard replacement for the listed Kia Sorento, Hyundai Santa Fe, and Hyundai Veracruz applications.