Delphi TD1759W Suspension Control Arm Bushing - Front Lower Forward Arm To Frame

Delphi Front Lower Control Arm Bushing

Delphi TD1759W is a suspension control arm bushing for the front lower forward arm to frame position. It is built for BMW applications that need precise suspension location, stable steering response, and consistent ride control.

Fits 2012-2021 BMW 228i, 230i, 328i, 328d, 330i, 330e, 335i, 340i, 428i, 430i, 435i, 440i, M235i, M240i, and ActiveHybrid 3 in the front lower forward arm to frame position.

• Suspension control arm bushing for front lower forward arm to frame mounting
• OE-focused dimensional and material analysis for proper fitment
• Engineered for temperature extremes below -40 C and above 120 C
• Tested through 720 hours of salt spray exposure
• Built for BMW front suspension service on 2 Series, 3 Series, and 4 Series models
• Part number TD1759W for catalog and cross-reference lookup

Application Details

This bushing is used in the front suspension to isolate the control arm from the frame while maintaining alignment and suspension geometry. Delphi applies OE-level engineering methods to its aftermarket steering and suspension portfolio, using dimensional and material checks to match the original part as closely as possible. This part cross-references Dorman - OE Solutions 533-640 for the same application.

Common Problems It Can Address

• Excessive front-end looseness or wandering
• Clunking or knocking from the lower control arm area
• Uneven tire wear related to worn suspension bushings
• Steering vibration or reduced road feel
• Suspension movement caused by deteriorated rubber or bonded material

Installation Notes

Verify the vehicle’s year, model, and front lower forward arm to frame position before installation. Inspect the control arm, mounting points, and surrounding suspension components for wear or damage during service. Proper alignment should be checked after replacement to confirm suspension geometry.

Quality Assurance

Delphi subjects this bushing to extreme temperature and corrosion testing and uses OE-based dimensional and material analysis to support fit and performance consistency. Part number TD1759W is backed by Delphi’s OE engineering approach for BMW suspension service.