Delphi TD1820W Suspension Control Arm Bushing - Front Lower Forward

Delphi TD1820W Suspension Control Arm Bushing

Delphi TD1820W is a standard replacement suspension control arm bushing built with rubber and steel for front lower forward applications. It is engineered for 2013-2018 Ford Fusion and 2013-2018 Lincoln MKZ models, with fitment focused on the front lower forward position.

Delphi applies OE-level dimensional and material analysis to help ensure proper match and consistent suspension performance. This part cross-references MOOG Chassis Products K201329 for the same application.

Key Features

• Suspension control arm bushing for the front lower forward position
• Rubber and steel construction for controlled compliance and support
• Gray finish
• Inside diameter: 16.1 mm
• Outside diameter: 66.1 mm
• Standard replacement grade
• Fits 2013-2018 Ford Fusion, front lower forward
• Fits 2013-2018 Lincoln MKZ, front lower forward

Detailed Description

The Delphi TD1820W suspension control arm bushing is built for vehicles that need a precise OE-style replacement at the front lower forward control arm location. Its rubber and steel design helps maintain the intended suspension geometry while supporting the control arm under normal road loads. For Ford Fusion and Lincoln MKZ owners searching for a front lower forward control arm bushing, TD1820W provides a direct-fit service part backed by Delphi’s OE-focused engineering approach.

Delphi subjects its steering and suspension components to extreme temperature and corrosion testing, along with dimensional and material analysis, to support fit and durability expectations in aftermarket service. The TD1820W part number is also a useful reference when comparing replacement options for 2013-2018 Ford Fusion and 2013-2018 Lincoln MKZ applications.

What It Helps Address

• Excessive play in the front lower forward control arm bushing
• Clunking or knocking from worn suspension bushings
• Imprecise steering feel caused by bushing wear
• Uneven suspension movement at the control arm pivot point
• Road vibration transferred through deteriorated rubber components

Installation Notes and Tips

Verify the vehicle’s year, make, model, and front lower forward position before ordering. Compare the inside diameter and outside diameter to the original bushing and inspect the control arm for wear, deformation, or corrosion before installation. Proper pressing tools and alignment procedures are typically required for control arm bushing service.

Quality Assurance

Delphi uses OE-based engineering, dimensional checks, and material analysis to support aftermarket fitment and performance. The TD1820W is tested for temperature extremes and salt spray exposure as part of Delphi’s validation process for steering and suspension components.