Delphi TD1990W Suspension Control Arm Bushing - Rear Lower Rearward

OE-Style Rear Lower Rearward Bushing

Delphi TD1990W is a premium suspension control arm bushing built for the rear lower rearward position. It uses natural rubber and a press-fit design to match OE-style dimensions and fitment for select Nissan applications.

Compatible with 2013-2017 Nissan Altima and 2016-2017 Nissan Maxima, this bushing is engineered for the rear lower rearward location. Delphi applies dimensional and material analysis to help ensure proper fit between the original and replacement part.

Key Features

• Part number: TD1990W
• Suspension control arm bushing for rear lower rearward placement
• Natural rubber bushing material with black finish
• Premium grade, press-fit mounting type
• OE equal construction for dimensional match
• No grease fitting and no mounting hardware included
• Compatible with power steering applications

Detailed Product Overview

Delphi TD1990W is a suspension control arm bushing designed for precise replacement in the rear lower rearward position. Its natural rubber construction and OE-equal sizing support consistent suspension articulation while maintaining the original mounting geometry. The bushing measures 55.00 mm in length, 37.20 mm in width and outside diameter, and 14.20 mm inside diameter, with a press-fit installation style.

This part fits 2013-2017 Nissan Altima, rear lower rearward, and 2016-2017 Nissan Maxima, rear lower rearward. If you are replacing a worn rear suspension bushing on a Nissan Altima or Nissan Maxima, TD1990W provides a direct-fit option built around OE dimensions. This part cross-references Mevotech Original Grade GS30443 for the same application.

Common Problems This Part Can Address

• Rear suspension clunking or knocking from worn control arm bushings
• Excessive play in the rear lower control arm assembly
• Uneven tire wear related to suspension movement
• Loose or unstable rear-end feel during braking or cornering
• Cracked, hardened, or deteriorated rubber bushing material

Installation Notes and Tips

TD1990W installs as a press-fit bushing, so the control arm typically must be removed and the old bushing pressed out before installation. Inspect the control arm, mounting bore, and surrounding suspension components for wear or damage before reassembly. Because mounting hardware is not included, reuse or replace related fasteners as needed based on the vehicle service procedure.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. That validation supports consistent material performance and OE-style compatibility for the Nissan Altima and Nissan Maxima applications listed above.