Delphi TD1992W Suspension Stabilizer Bar Bushing Kit - Front

Front Stabilizer Bar Bushing Kit

Restore front suspension control with the Delphi TD1992W stabilizer bar bushing kit. This OE-style replacement uses rubber bushings to help maintain proper sway bar location and reduce unwanted movement at the front of the vehicle.

Compatible with select Subaru Crosstrek, Forester, WRX, WRX STI, and XV Crosstrek applications, the TD1992W is built for direct-fit service on front suspension stabilizer bar mounting points.

Key Features

• Rubber construction for standard replacement service
• Front position application
• Two-bushing kit
• Black finish
• Inside diameter: 0.740 in. (18.8 mm)
• Dimensions: 1.543 in. length, 1.772 in. width, 1.843 in. height
• No grease fitting, bracket, or mounting hardware included

Detailed Description

Delphi TD1992W is a suspension stabilizer bar bushing kit engineered for front sway bar service. Delphi applies OE-level dimensional and material analysis to help ensure proper fit between the original part and the aftermarket replacement. The rubber bushing design supports stable sway bar mounting and consistent front-end response on Subaru Crosstrek, Forester, WRX, WRX STI, and XV Crosstrek models.

This part cross-references MOOG Chassis Products K201913 and interchange part number 20414SG000 for the same application. Use TD1992W when replacing worn front stabilizer bar bushings on 2013-2015 Subaru XV Crosstrek, 2014-2021 Subaru Forester, 2015-2020 Subaru WRX, 2015-2020 Subaru WRX STI, and 2016-2021 Subaru Crosstrek.

Common Issues This Part Addresses

• Front sway bar clunking or rattling
• Excessive play at the stabilizer bar mounting point
• Worn, cracked, or flattened rubber bushings
• Loose front suspension feel during cornering
• Noise from deteriorated stabilizer bar bushings

Installation Notes and Tips

Install on the front stabilizer bar location only. Inspect the sway bar, brackets, and surrounding suspension components for wear before installation. Because mounting hardware and brackets are not included, reuse or replace those components as needed during service. Verify bushing dimensions and vehicle application before installation on your Subaru Forester, Subaru Crosstrek, or WRX platform.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure testing. TD1992W is built using Delphi’s OE-focused engineering and material analysis for consistent aftermarket replacement quality.