Delphi TD247W Suspension Control Arm Bushing - Front Lower Inner Forward

OE-Style Front Lower Inner Forward Bushing

Delphi TD247W is a suspension control arm bushing built for the front lower inner forward position. It uses rubber construction and a press-fit mounting style to support a precise OE-style replacement for worn suspension pivot points. This part is a practical choice for drivers searching for a Delphi TD247W suspension control arm bushing for Honda Civic or Toyota Corolla front suspension service.

Key Features

• Rubber bushing material for controlled suspension movement and vibration isolation
• Press-fit mounting type for OE-style installation
• Standard replacement grade for routine suspension repair
• Dimensions: 20.0 mm inside diameter, 45.5 mm outside diameter, 59.0 mm height
• Position: front lower inner forward
• Built using Delphi OE dimensional and material analysis for fit consistency

Detailed Description

Delphi TD247W is engineered as a suspension control arm bushing for the front lower inner forward location. The rubber construction helps maintain suspension articulation while reducing harshness transmitted through the chassis. Delphi applies OE-focused testing and material analysis to support dimensional accuracy and compatibility between the original part and the aftermarket replacement. The part is exposed to extreme temperature testing from below -40 degrees C to over 120 degrees C, along with extended salt-spray exposure, to evaluate durability in demanding conditions. For shoppers comparing Delphi TD247W against other OE-style bushings, this part cross-references Gates 352334 and 352349 for the same application.

What It Helps Repair

• Clunking or knocking from the front suspension
• Excessive play at the control arm pivot point
• Uneven tire wear caused by worn suspension bushings
• Loose or imprecise steering feel during road use
• Vibration transfer from worn rubber suspension components

Installation Notes and Tips

Fits front lower inner forward suspension locations where a press-fit control arm bushing is specified. Confirm the original bushing dimensions before installation, especially the 20.0 mm inside diameter, 45.5 mm outside diameter, and 59.0 mm height. Proper press tools are typically required for bushing replacement, and the control arm should be inspected for wear, corrosion, or distortion before reassembly. For vehicle-specific searches, this Delphi TD247W bushing is commonly researched for Honda Civic and Toyota Corolla front suspension repair applications.

Quality Assurance

Delphi uses OE-based engineering, dimensional analysis, and material testing to support replacement part consistency. The bushing is evaluated for temperature extremes and salt-spray exposure to reflect real-world undercar conditions. Delphi TD247W is a standard replacement suspension bushing built to align with OE fit and function expectations.