Delphi TD282W Suspension Control Arm Bushing - Front Lower or Front Lower Forward

Delphi TD282W Front Lower Control Arm Bushing

Delphi TD282W is a rubber-to-metal suspension control arm bushing built for front lower and front lower forward applications. It is a press-fit, standard replacement part engineered for vehicles that need precise suspension location and consistent ride control.

Key Features

• Rubber-to-metal construction for controlled suspension movement
• Press-fit mounting type for OE-style installation
• Black finish
• Dimensions: 60.5 mm length, 12.0 mm inside diameter, 35.0 mm outside diameter
• Front lower and front lower forward positions, depending on vehicle application
• Delphi OE-focused dimensional and material analysis for fit consistency

Detailed Description

The Delphi TD282W suspension control arm bushing is made for front suspension service where the control arm must stay properly located under load. Its rubber-to-metal design helps isolate road vibration while maintaining the alignment and handling characteristics expected from an OE-style replacement. Delphi validates its steering and suspension components through extreme temperature exposure and salt-spray testing, supporting durability in demanding driving conditions. This part cross-references Beck/Arnley 101-3817 for the same application.

Compatible With 1985-1993 Volkswagen Cabriolet, front lower forward; 1987-1988 Porsche 924, front lower; 1983-1986 Porsche 944, front lower; 1981-1984 Volkswagen Jetta, front lower forward; and 1980-1984 Volkswagen Rabbit Convertible, front lower forward. The Delphi TD282W is a direct-fit option for owners searching for a front lower control arm bushing for Volkswagen Cabriolet, Porsche 944, or Volkswagen Jetta suspension repair.

What It Helps Address

• Excessive play in the front control arm
• Clunking or knocking from worn suspension bushings
• Imprecise steering feel caused by bushing wear
• Uneven tire wear related to suspension movement
• Loss of front-end stability under braking or cornering

Installation Notes and Tips

Press-fit bushings require proper removal and installation tools to avoid damaging the control arm or the new bushing. Confirm the position before ordering, since this part is used in front lower and front lower forward locations depending on the vehicle. After installation, inspect alignment settings and verify that all suspension fasteners are tightened to the vehicle manufacturer’s specifications.

Quality Assurance

Delphi applies OE-level material and dimensional analysis to help ensure consistent fit and performance. The part is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate corrosion resistance and durability.