Delphi TD387W Suspension Control Arm Bushing - Front Lower or Front Lower Inner Forward

Delphi TD387W Suspension Control Arm Bushing

Delphi TD387W is a front lower suspension control arm bushing built with a rubber-steel construction for OE-style replacement performance. It is engineered for press-fit installation and sized for the front lower and front lower inner forward positions on select Volvo, Mitsubishi, and Dodge applications.

Key Features

• Rubber-steel construction for controlled compliance and durability
• Press-fit mounting type for direct suspension service
• Standard replacement grade for routine chassis repair
• Black finish
• Dimensions: 59.5 mm length, 59.6 mm height, 12.7 mm wall thickness, 12.2 mm inside diameter
• Delphi OE-focused dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40 C and above 120 C, plus 720 hours of salt spray exposure

Detailed Description

Delphi TD387W is a suspension control arm bushing for front lower and front lower inner forward locations, depending on vehicle application. It is a direct-fit, press-fit replacement that supports suspension articulation while helping maintain proper control arm location and bushing integrity. This part cross-references MOOG Chassis Products K200340 for the same application.

Compatible With 2000-2004 Volvo S40, front lower inner forward; 2000-2004 Volvo V40, front lower inner forward; 1993-2002 Mitsubishi Mirage, front lower; and 1993-1995 Dodge Colt, front lower. Delphi TD387W is a practical choice when servicing worn bushings on these platforms, including Volvo S40, Volvo V40, and Mitsubishi Mirage front suspension repairs.

What It Helps Address

• Excessive play in the front lower control arm bushing
• Clunking or knocking from worn suspension bushings
• Uneven tire wear related to bushing deterioration
• Loose or imprecise front-end feel during braking and cornering
• Suspension noise caused by cracked or separated rubber-steel bushings

Installation Notes and Tips

Verify the exact position on your vehicle before ordering, since this part is listed for front lower and front lower inner forward applications. Press-fit installation requires proper suspension service tools and careful bushing alignment during installation. Inspect the control arm and surrounding hardware for wear before reassembly, and confirm dimensions against the removed part when possible. Delphi TD387W is also referenced by part number TD387W during catalog lookup and service ordering.

Quality Assurance

Delphi applies OE-focused engineering practices to its aftermarket steering and suspension portfolio, including dimensional and material analysis for fit consistency. The part is validated through temperature and corrosion testing to reflect demanding undercar conditions and long-term service exposure.