Delphi TD4010W Suspension Stabilizer Bar Bushing Kit - Front

Delphi TD4010W Front Stabilizer Bar Bushing Kit

Delphi TD4010W is a front suspension stabilizer bar bushing kit built for OE-style replacement on select Chrysler, Dodge, and Plymouth minivans. It uses neoprene rubber and steel construction to support sway bar control and help maintain consistent front-end handling.

Key Features

• OE-style replacement stabilizer bar bushing kit for the front suspension
• Neoprene rubber and steel construction
• Black finish
• Inside diameter: 25.0 mm (0.984 in.)
• Outside diameter: 51.0 mm (2.008 in.)
• Width: 51.0 mm (2.008 in.)
• Height: 46.0 mm (1.811 in.)
• Standard replacement item grade
• Mounting hardware not included

Detailed Description

Delphi TD4010W is engineered for front stabilizer bar service where worn bushings can affect sway bar performance and suspension response. Delphi applies OE-level dimensional and material analysis to support proper fit and material compatibility, and the part is tested for extreme temperature exposure from below -40 degrees C to over 120 degrees C, along with 720 hours of salt spray exposure. This part cross-references MOOG Chassis Products (e.g., K7350, K200600) for the same application.

Compatible with 1996-2000 Chrysler Town & Country, front; 2000 Chrysler Grand Voyager, front; 2000 Chrysler Voyager, front; 1996-2000 Dodge Caravan, front; 1996-2000 Dodge Grand Caravan, front; 1996-2000 Plymouth Grand Voyager, front; and 1996-2000 Plymouth Voyager, front. Delphi TD4010W is a direct-fit front stabilizer bar bushing kit for these applications.

What It Helps Address

• Front sway bar bushing wear
• Clunking or rattling from the front suspension
• Excessive play at the stabilizer bar mounting point
• Reduced steering feel caused by deteriorated bushings
• Noise from cracked or hardened rubber bushings

Installation Notes and Tips

Inspect the stabilizer bar, brackets, and surrounding suspension components before installation. Clean the mounting surfaces thoroughly and verify the bushing dimensions match the OE application for proper seating. Because mounting hardware is not included, reuse or replace related hardware as needed based on condition.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its aftermarket steering and suspension components. TD4010W is built with materials and dimensions selected to support consistent fitment and durability in front suspension service.