Delphi TD4018W Suspension Control Arm Bushing - Front Lower Forward

Delphi TD4018W Front Lower Forward Bushing

Delphi TD4018W is a suspension control arm bushing built for the front lower forward position. It uses a rubber-steel construction and OE-based dimensional and material analysis to support proper fit and consistent suspension performance on the vehicle.

Key Features

• Rubber-steel construction for controlled compliance and durability
• Pressed mounting type for direct control arm service
• Standard replacement grade for routine suspension repair
• Black finish
• Dimensions: 53.5 mm length, 12.2 mm inside diameter, 32.0 mm outside diameter
• Compatible with 2011-2017 Ford Fiesta, front lower forward

Detailed Description

This Delphi suspension control arm bushing is engineered for the front lower forward location on the 2011-2017 Ford Fiesta. Delphi applies OE-focused testing and dimensional analysis to aftermarket steering and suspension parts, helping maintain the intended bushing geometry and material characteristics for the application. The TD4018W part number is also referenced in OE-style replacement searches for Ford Fiesta front suspension service, and TD4018W is a practical match for technicians replacing worn control arm bushings on this platform.

This part cross-references MOOG Chassis Products (e.g., K201326) for the same application.

What It Helps Address

• Front suspension looseness from worn control arm bushings
• Clunking or knocking from deteriorated rubber-steel bushings
• Excessive play at the front lower forward control arm mount
• Uneven steering response caused by bushing wear
• Suspension noise during braking, turning, or road impacts

Installation Notes and Tips

TD4018W uses a pressed mounting design, so the old bushing must be removed from the control arm and the replacement installed with proper press tools. Inspect the control arm, mounting bore, and adjacent suspension components before assembly. Because this bushing is for the front lower forward position, verify side and application details against the vehicle service information for the 2011-2017 Ford Fiesta before installation.

Quality Assurance

Delphi subjects its OE-based suspension components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. The brand also uses dimensional and material analysis to support OE-style fit and material consistency for the TD4018W.