Delphi TD4052W Suspension Stabilizer Bar Bushing Kit - Front

Delphi Front Stabilizer Bar Bushing Kit TD4052W

Delphi TD4052W is a front suspension stabilizer bar bushing kit built as a standard replacement for OE-style service. It is engineered for the front suspension on select Ford Super Duty trucks, including 2011-2016 Ford F-250 Super Duty and 2011-2016 Ford F-350 Super Duty with Monobeam Suspension and Extended Axle (Fatboy) Axle.

With a black finish, a 1.23 in. (31.3 mm) inside diameter, 1.66 in. width, and 2.47 in. (62.7 mm) height, this bushing kit is sized for direct-fit suspension service. Delphi TD4052W is a practical choice when replacing worn front sway bar bushings on Ford F-250 Super Duty and Ford F-350 Super Duty applications.

Key Features

• Front suspension stabilizer bar bushing kit
• Standard replacement item grade
• Black bushing construction
• Inside diameter: 1.23 in. / 31.3 mm
• Width: 1.66 in.
• Height: 2.47 in. / 62.7 mm
• No grease fitting included
• No mounting hardware included
• Fits front position only

Detailed Description

Delphi applies OE-focused dimensional and material analysis to help ensure proper fit and function in aftermarket steering and suspension service. TD4052W is built for front stabilizer bar mounting on the specified Ford Super Duty platforms, where correct bushing sizing is important for maintaining sway bar location and suspension response. This part cross-references Ford 7C3Z-5484-E and MOOG Chassis Products K200885 for the same application.

For buyers searching for a front sway bar bushing kit for 2011-2016 Ford F-250 Super Duty or 2011-2016 Ford F-350 Super Duty, Delphi TD4052W provides a direct replacement option with OE-oriented dimensions and material validation.

What It Helps Address

• Front stabilizer bar movement caused by worn bushings
• Clunking or rattling from the front suspension area
• Excess sway bar play during cornering
• Loss of consistent front-end suspension feel
• Fitment issues from deteriorated OE-style bushings

Installation Notes and Tips

Verify the vehicle uses Monobeam Suspension with Extended Axle (Fatboy) Axle before ordering. Confirm the stabilizer bar diameter and bushing dimensions against the original part, and inspect the sway bar, brackets, and surrounding hardware for wear before installation. Because mounting hardware is not included, reuse or replace related components as needed during service.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. These validation steps support durability for front suspension service on Ford F-250 Super Duty and Ford F-350 Super Duty applications.