Delphi TD4060W Suspension Stabilizer Bar Bushing Kit - Front

Front Stabilizer Bar Bushing Kit for Ford and Lincoln

Delphi TD4060W is a front suspension stabilizer bar bushing kit built as a standard replacement for select Ford and Lincoln applications. It is sized for a 32.0 mm inside diameter and finished in black for a direct-fit service part that supports front sway bar mounting.

Key Features

• Front suspension stabilizer bar bushing kit
• 32.0 mm inside diameter for the specified OE-style fit
• Black standard replacement bushing design
• No grease fitting included
• No mounting hardware included
• Delphi TD4060W part number for easy identification

Application Details

Compatible with front suspension service on 2004-2008 Ford F-150, 2006-2008 Lincoln Mark LT, 2006 Ford Expedition, and 2005 Ford Expedition built from 11/29/2004. This Delphi TD4060W stabilizer bar bushing kit is a direct service option for front sway bar support on these Ford F-150, Lincoln Mark LT, and Expedition applications.

Delphi applies OE-focused dimensional and material analysis to help maintain proper compatibility between the replacement bushing and the original suspension layout. The part is tested for temperature extremes and salt-spray exposure to reflect demanding underbody conditions.

This part cross-references Ford 5L3Z-5484-AA and MOOG Chassis Products K200331 for the same application.

Common Problems This Part Can Address

• Front sway bar bushing wear that can contribute to looseness in the suspension
• Clunking or rattling from the front stabilizer bar area
• Excess movement at the stabilizer bar mounting point
• Degraded rubber bushing condition from age, heat, or road exposure
• Restoring proper front suspension support on the listed Ford and Lincoln models

Installation Notes and Tips

Verify the stabilizer bar diameter before installation to confirm the 32.0 mm fitment. Inspect the sway bar, brackets, and surrounding mounting surfaces for wear or corrosion before replacing the bushing. Because mounting hardware is not included, reuse or source the required hardware as needed for the vehicle.

Quality Assurance

Delphi uses OE-based engineering and extensive dimensional and material analysis for aftermarket steering and suspension parts. The brand also subjects parts to temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure, to evaluate durability in harsh service conditions.