Delphi TD4064W Suspension Control Arm Bushing - Front Upper

OE-Style Front Upper Bushing

Delphi TD4064W is a suspension control arm bushing built as a standard replacement for press-in applications. It uses rubber construction and OE-focused dimensional analysis to support a precise match for the intended suspension setup.

Key Features

• Rubber construction for controlled suspension movement and isolation.
• Press-in mounting type for serviceable control arm applications.
• Standard replacement grade for OE-style service.
• Black and gray finish.
• Delphi OE expertise applied to aftermarket steering and suspension parts.

Detailed Description

The Delphi TD4064W suspension control arm bushing is engineered around OE dimensions and material characteristics to help maintain the original suspension geometry. Its rubber design and press-in fitment make it a direct service part for front upper control arm locations on select Nissan, INFINITI, and Suzuki applications. This part cross-references Nissan 54524EA00A for the same application. Delphi TD4064W is a practical choice when replacing worn bushings on the Armada, Frontier, Pathfinder, TITAN, Xterra, QX80, QX56, Pathfinder Armada, and Equator.

What It Is Used For

• Restoring control arm bushing support when the original rubber has worn.
• Reducing looseness in the suspension joint.
• Addressing noise from deteriorated bushing material.
• Correcting fitment issues caused by dimensional wear.

Installation Notes and Tips

Fits 2005-2015 Nissan Armada, front upper; 2005-2018 Nissan Frontier, front upper; 2014-2017 INFINITI QX80, front upper; 2004-2015 Nissan TITAN, front upper; 2005-2015 Nissan Xterra, front upper; 2004-2013 INFINITI QX56, front upper; 2005-2012 Nissan Pathfinder, front upper; 2009-2012 Suzuki Equator, front upper; 2004 Nissan Pathfinder Armada, front upper; 2017-2018 Nissan Armada, front upper; 2017 Nissan TITAN, front upper. Press-in installation requires proper suspension service tools and accurate alignment of the bushing in the control arm. Verify the vehicle application and position before installation. TD4064W should be matched to the listed front upper fitments only.

Quality Assurance

Delphi applies OE-focused testing to this part, including exposure to temperatures below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray testing. Dimensional and material analysis is used to support compatibility between the OE and aftermarket part.