Delphi TD4072W Suspension Stabilizer Bar Bushing Kit - Front

Delphi Front Stabilizer Bar Bushing Kit

Restore front suspension control with the Delphi TD4072W stabilizer bar bushing kit. This OE-style rubber bushing is built for front-position applications on select Nissan Sentra and Nissan 200SX models, helping maintain proper sway bar support and consistent suspension response.

• OE replacement suspension stabilizer bar bushing kit for the front position
• Rubber construction with a black finish
• Inside diameter: 1.1 in. / 28.0 mm
• Outside diameter: 1.26 in. / 32.0 mm
• Width: 1.646 in. / 41.8 mm
• Height: 1.87 in. / 47.5 mm
• Standard replacement item grade
• Fits front applications on 1995-1999 Nissan Sentra and 1995-1998 Nissan 200SX

OE-Style Fit and Material

The Delphi TD4072W is a front stabilizer bar bushing kit made from rubber for controlled sway bar mounting and consistent suspension geometry. Delphi applies dimensional and material analysis to match OE fitment expectations, and the part is tested for temperature extremes and salt-spray exposure to support long-term service in demanding conditions. This part cross-references Beck/Arnley 101-6387 for the same application.

Vehicle Fitment

• Fits 1995-1999 Nissan Sentra, front
• Fits 1995-1998 Nissan 200SX, front

Common Symptoms This Part May Address

• Front-end clunking or rattling over bumps
• Excess sway bar movement at the front suspension
• Worn, cracked, or flattened stabilizer bar bushings
• Reduced steering stability during cornering
• Noise caused by loose sway bar support points

Installation Notes

Confirm the front sway bar diameter and bushing dimensions before installation. Inspect the stabilizer bar, brackets, and surrounding suspension components for wear or corrosion, and replace any damaged mounting surfaces to help ensure proper fit on Nissan Sentra and Nissan 200SX front applications. Verify orientation and seating during assembly so the bushing supports the bar evenly.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its aftermarket steering and suspension portfolio. The TD4072W is built as a standard replacement part and is evaluated for dimensional accuracy, material compatibility, temperature resistance, and corrosion exposure to support dependable service.