Delphi TD4089W Suspension Stabilizer Bar Bushing Kit - Front To Control Arm

Delphi TD4089W Front Stabilizer Bar Bushing Kit

Delphi TD4089W is a standard replacement front stabilizer bar bushing kit made from rubber for the front-to-control-arm location. It is built for 1.4-inch inside diameter bars and is listed for select Dodge Dakota and Dodge Durango applications with a 1.40-inch diameter bar.

Key Features

• Rubber construction for stabilizer bar support and isolation
• Inside diameter: 1.4 in.
• Outside diameter: 1.8 in.
• Standard replacement grade for direct-service use
• Front to control arm position
• Delphi OE-focused dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation

Detailed Description

Delphi TD4089W is a front stabilizer bar bushing kit engineered for vehicles using a 1.40-inch diameter bar at the front control arm location. It is a direct-service suspension component for 2000-2004 Dodge Dakota and 2000-2003 Dodge Durango applications, and the rubber material helps maintain stabilizer bar positioning while reducing unwanted movement at the mounting point. This part number, TD4089W, reflects Delphi’s OE-based approach to aftermarket steering and suspension service, with dimensional and material checks used to support proper part matching. This part cross-references MOOG Chassis Products K7464 for the same application.

Vehicle Fitment

• Fits 2000-2004 Dodge Dakota, front to control arm, with 1.40in diameter bar.
• Fits 2000-2003 Dodge Durango, front to control arm, with 1.40in diameter bar.

Common Repair Uses

• Restoring stabilizer bar support when the original bushing is worn or compressed
• Reducing front suspension clunking or looseness at the control arm mount
• Addressing sway bar movement caused by deteriorated rubber bushings
• Replacing a serviceable front stabilizer bar bushing on Dodge Dakota or Dodge Durango models

Installation Notes and Tips

Confirm the stabilizer bar diameter before ordering, since this TD4089W application is specified for a 1.40-inch bar. Verify the front-to-control-arm mounting location on the vehicle and compare the old bushing dimensions to the listed inside and outside diameters for proper match-up.

Quality Assurance

Delphi validates this suspension bushing with temperature cycling and salt-spray exposure testing, along with dimensional and material analysis to support OE-style fit and durability expectations.