Delphi TD4093W Suspension Stabilizer Bar Bushing Kit - Front To Control Arm

Delphi TD4093W Front Stabilizer Bar Bushing Kit

Delphi TD4093W is a standard replacement front stabilizer bar bushing kit made from rubber for the front-to-control-arm position. It is built for 2003-2004 Dodge Dakota and 2003 Dodge Durango applications with a 1.30-inch diameter bar, helping restore proper sway bar support and suspension control.

Key Features

• Rubber construction for OE-style suspension isolation
• Inside diameter: 1.295 in.; outside diameter: 1.8 in.
• Standard replacement grade for front stabilizer bar service
• Positioned front to control arm
• Fits 2003-2004 Dodge Dakota, front to control arm, with 1.30in diameter bar
• Fits 2003 Dodge Durango, front to control arm, with 1.30in diameter bar

Detailed Description

Delphi TD4093W is engineered as a front stabilizer bar bushing kit for vehicles that use a 1.30-inch sway bar. The rubber material helps maintain the bar’s location while reducing unwanted movement at the control arm connection. This part cross-references MOOG Chassis Products K200162 for the same application. Delphi applies OE-focused dimensional and material analysis to support proper fit on Dodge Dakota and Dodge Durango suspension setups.

What It Helps Address

• Clunking or knocking from worn front sway bar bushings
• Excessive play at the stabilizer bar-to-control-arm connection
• Reduced front-end stability during cornering
• Suspension noise caused by deteriorated rubber bushings
• Loose or inconsistent sway bar support on the front axle area

Installation Notes and Tips

Confirm the stabilizer bar diameter before ordering; this part is specified for a 1.30-inch bar. Verify the front-to-control-arm mounting location on the vehicle and inspect the bar, control arm contact points, and surrounding suspension components for wear before installation. For fitment, use Delphi TD4093W on 2003-2004 Dodge Dakota and 2003 Dodge Durango front suspension applications only when the bar diameter matches the listed specification.

Quality Assurance

Delphi subjects its OE-based steering and suspension components to temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. That OE-oriented validation supports consistent material performance and fit accuracy for TD4093W.