Delphi TD4094W Suspension Stabilizer Bar Bushing Kit - Front

Delphi Front Stabilizer Bar Bushing Kit

Delphi TD4094W is a front suspension stabilizer bar bushing kit built as a standard replacement for OE-style service. It uses rubber construction and an inside diameter of 0.885 in. for the specified 22 mm bar applications, helping restore proper sway bar support and front-end control.

Engineered from Delphi OE expertise, this part is tested for temperature extremes below -40 C and above 120 C, and exposed to 720 hours of salt spray for durability validation. It is a direct-fit option for select Chevrolet Cobalt, Pontiac G5, Chevrolet HHR, Saturn Ion, and Pontiac Pursuit front suspension applications.

Key Features

• Front suspension stabilizer bar bushing kit
• Rubber material for standard replacement service
• Inside diameter: 0.885 in.
• Position: front
• Built for 22 mm bar diameter applications where specified
• OE-focused dimensional and material analysis for fitment accuracy

Detailed Description

Delphi TD4094W is a front sway bar bushing solution for vehicles that use a 22 mm stabilizer bar or the listed Sport Ride (FE3) suspension configuration. It is a practical replacement for worn bushings that can allow excess bar movement, noise, or reduced steering response. This part cross-references MOOG Chassis Products K200047 for the same application.

Compatible With 2009-2010 Chevrolet Cobalt, front; 2007-2010 Pontiac G5, front; 2005-2008 Chevrolet Cobalt, front for vehicle with Suspension system Sport Ride (FE3); 2007 Chevrolet HHR, front; 2003-2007 Saturn Ion, front; and 2005-2006 Pontiac Pursuit, front for vehicle with Suspension system Sport Ride (FE3). Delphi TD4094W is a focused OE-style replacement for these front suspension applications.

What It Helps Address

• Front sway bar clunking or rattling from worn bushings
• Excess stabilizer bar movement in the front suspension
• Loose or imprecise front-end handling feel
• Noise caused by deteriorated rubber bushing material
• Fitment issues when replacing an OE-style front stabilizer bar bushing

Installation Notes and Tips

Verify the stabilizer bar diameter before ordering, since this part is specified for 22 mm bar diameter applications and a 0.885 in. inside diameter. Confirm the vehicle’s front suspension configuration and match the listed model-year application before installation. Inspect the stabilizer bar and surrounding hardware for wear or damage that could affect bushing performance.

Quality Assurance

Delphi applies OE-level engineering and validation to its aftermarket steering and suspension parts. TD4094W is evaluated for temperature resistance and corrosion exposure, with dimensional and material analysis used to support proper OE-to-aftermarket compatibility.