Delphi TD4112W Suspension Stabilizer Bar Bushing Kit - Front

Delphi TD4112W Front Stabilizer Bar Bushing Kit

Delphi TD4112W is a front suspension stabilizer bar bushing kit built as a standard replacement for OE-style service. It uses rubber construction and a 1.005 inside diameter to match the specified bar diameter on select Chrysler Sebring and Dodge Avenger applications.

Key Features

• Rubber bushing material for suspension service
• 1.005 inside diameter
• Standard replacement grade
• Front position application
• OE-focused dimensional and material analysis for fitment consistency
• Tested for temperature extremes and salt-spray exposure during validation

Application Details

Compatible with 2007-2010 Chrysler Sebring, front, with 26.06mm bar diameter, and 2008-2010 Dodge Avenger, front, with 26.06mm bar diameter. Delphi TD4112W is a direct-fit front stabilizer bar bushing kit for these listed vehicles, helping restore the stabilizer bar interface at the front suspension. This part cross-references Chrysler 05272590AE and K200218 for the same application.

What This Part Helps Address

• Front sway bar movement caused by worn bushings
• Clunking or squeaking from the stabilizer bar area
• Excess play at the front suspension mounting point
• Loss of consistent bar-to-frame contact on the listed applications

Installation Notes and Tips

Verify the front stabilizer bar diameter is 26.06mm before installation. Confirm the existing bushing bore and mounting location match the listed application, and inspect the stabilizer bar and surrounding hardware for wear before reassembly. Delphi TD4112W should be installed on the front suspension only for the vehicles shown.

Quality Assurance

Delphi applies OE engineering practices to its aftermarket steering and suspension portfolio. This bushing kit is validated through dimensional and material analysis, along with environmental testing that includes sub-zero and high-temperature exposure and extended salt-spray testing.