Delphi TD4185W Suspension Stabilizer Bar Bushing Kit - Front

Delphi Front Stabilizer Bar Bushing Kit TD4185W

Restore front sway bar support with this Delphi suspension stabilizer bar bushing kit. Built with rubber and standard replacement specifications, TD4185W is made for front applications on select Dodge, Chrysler, and Dodge performance sedans and coupes, including Chrysler 300, Dodge Charger, Dodge Challenger, and Dodge Magnum.

Key Features

• Rubber construction for front stabilizer bar mounting support
• Standard replacement grade for OE-style service fit
• Inside diameter: 1.06 in.
• Outside diameter: 2.42 in.
• Front position application
• Delphi part number TD4185W

Application Details

TD4185W is a front suspension stabilizer bar bushing kit engineered for vehicles with a 1.06-inch bar diameter where specified. It is listed for 2005-2014 Chrysler 300, front; 2006-2014 Dodge Charger, front with 1.06in bar diameter; 2009-2013 Dodge Challenger, front with 1.06in bar diameter; 2005-2007 Dodge Magnum, front with 1.06in bar diameter; 2008 Dodge Magnum, front to frame; 2008 Dodge Challenger, front to frame; 2014-2015 Dodge Challenger, front to frame; and 2015 Dodge Charger, front. Delphi applies OE-focused dimensional and material analysis to help maintain proper fit between the original and replacement part.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Front sway bar movement caused by worn rubber bushings
• Clunking or rattling from the front suspension area
• Excessive play at the stabilizer bar mounting point
• Reduced steering response from deteriorated bushing material
• Service replacement for Chrysler 300, Dodge Charger, Dodge Challenger, and Dodge Magnum front suspension wear

Installation Notes

Verify the front stabilizer bar diameter before installation, especially on 2005-2014 Chrysler 300 and 2006-2014 Dodge Charger applications listed with a 1.06-inch bar diameter. Confirm the vehicle position and mounting style against the fitment notes, including front-to-frame listings where shown. Inspect the stabilizer bar and mounting surfaces for wear before installing the new bushing.

Quality Assurance

Delphi subjects its OE-based steering and suspension components to temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. These validation steps support consistent material performance for everyday suspension service.