Delphi TD4256W Suspension Control Arm Bushing - Rear Lower Rearward

Delphi Rear Lower Rearward Control Arm Bushing

Restore suspension joint integrity with this Delphi suspension control arm bushing for the rear lower rearward position. Built with rubber-to-metal construction, Delphi TD4256W is a standard replacement part for Jeep Liberty applications that need precise bushing support and OE-style fitment.

Compatible with 2002-2006 Jeep Liberty rear lower rearward suspension locations, including 2004-2006 Jeep Liberty with Type B. Delphi TD4256W is engineered for the rear lower rearward position and is built to match the dimensional and material requirements of the original application.

Key Features

• Rubber-to-metal construction for suspension isolation and load control
• Standard replacement design for direct service use
• Inside diameter: 0.574 in.
• Length: 2.61 in.
• Position: rear lower rearward
• OE-focused dimensional and material analysis for application matching
• Tested for temperature extremes and salt-spray exposure during validation

Detailed Description

Delphi TD4256W is a suspension control arm bushing designed for the rear lower rearward location on Jeep Liberty models from 2002 through 2006. The rubber-to-metal design helps maintain suspension geometry while isolating road vibration through the control arm mounting point. For buyers searching for a Jeep Liberty rear lower rearward control arm bushing or a Delphi TD4256W replacement, this part provides a direct-service solution built around OE-style dimensions and material specifications.

Delphi applies OE engineering methods to its aftermarket steering and suspension portfolio, including dimensional and material analysis to support proper part matching. This part cross-references MOOG Chassis Products K200257 for the same application.

What It Helps Address

• Clunking or knocking from worn rear suspension bushings
• Excessive play at the rear lower control arm mounting point
• Uneven suspension movement caused by deteriorated rubber
• Loss of alignment stability from bushing wear
• Road vibration transferred through the rear suspension

Installation Notes and Tips

Install TD4256W in the rear lower rearward control arm position only. Verify the vehicle is a 2002-2006 Jeep Liberty before ordering, and confirm whether the application is Type B on 2004-2006 models. Inspect the control arm and surrounding hardware for wear before pressing in the new bushing, and follow factory service procedures for removal and installation.

Quality Assurance

Delphi validates this bushing through extreme-temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt-spray exposure. These checks support durability expectations for daily-driven suspension service and help confirm OE-style performance characteristics.