Delphi TD4261W Suspension Stabilizer Bar Bushing Kit - Rear

Rear Stabilizer Bar Bushing Kit for Honda and Acura

Delphi TD4261W is a rear suspension stabilizer bar bushing kit built as a standard replacement for select Honda and Acura applications. It uses rubber construction and OE-focused dimensional analysis to support proper fitment on the rear stabilizer bar.

• Rubber bushing material for suspension service
• Standard replacement grade
• Inside diameter: 0.755 in.
• Width: 1.466 in.
• Rear position application

OE-Focused Replacement Design

Delphi applies OE engineering and material analysis to its aftermarket steering and suspension portfolio, and TD4261W follows that approach for rear stabilizer bar service. The part is tested for extreme temperature exposure below -40 degrees C and above 120 degrees C, and it is subjected to 720 hours of salt spray testing to evaluate durability in harsh conditions. This part cross-references Dorman - Premium BSK59679PR for the same application.

Vehicle Fitment

• Fits 2003-2008 Honda Pilot, rear.
• Fits 2001-2006 Acura MDX, rear.

Common Repair Symptoms

• Rear suspension noise over bumps
• Excessive sway bar movement at the rear axle
• Worn or cracked stabilizer bar bushings
• Loose-feeling rear suspension response

Installation Notes

Verify the rear stabilizer bar diameter and bushing dimensions before installation. Inspect the stabilizer bar, brackets, and surrounding suspension components for wear or corrosion during service. Confirm correct rear placement on the Honda Pilot or Acura MDX before final assembly. Part number TD4261W should be matched to the vehicle application and measured dimensions for proper service.

Quality Assurance

Delphi uses OE expertise, dimensional validation, and material analysis to support aftermarket fit and performance. TD4261W is evaluated through temperature and corrosion testing to help confirm durability for rear suspension use.