Delphi TD4429W Suspension Strut Rod Bushing Kit - Front To Frame

Delphi Front Strut Rod Bushing Kit for Windstar

Delphi TD4429W is a standard replacement suspension strut rod bushing kit for the front-to-frame position on select Ford Windstar models. Built with natural rubber and sized to OE-style dimensions, it supports consistent suspension location and helps maintain proper front-end control.

Key Features

• Part number TD4429W for easy identification
• Front to frame suspension strut rod bushing kit
• Natural rubber (NR) bushing material
• Black bushing finish
• Standard replacement grade
• OE-focused dimensional and material analysis for fitment alignment
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation

Detailed Description

This Delphi suspension strut rod bushing kit is engineered for the front-to-frame location on 1995-2003 Ford Windstar applications. The bushing measures 57.0 mm outside diameter, 21.0 mm inside diameter, and 42.7 mm in height and length, with an 18.0 mm wall thickness, helping match OE-style geometry for the suspension mounting point. Delphi TD4429W is built from natural rubber to provide a direct replacement solution for Windstar front suspension service.

Delphi applies OE-based testing and dimensional analysis to its aftermarket steering and suspension portfolio, helping ensure the part aligns with original equipment requirements. This part cross-references Monroe Shocks & Struts (e.g., N804018S36M) for the same application.

What It Helps Address

• Front suspension looseness at the strut rod mounting point
• Excessive movement or play in the front-to-frame bushing area
• Noise from worn rubber suspension bushings
• Uneven front-end response caused by deteriorated bushing material
• Restoration of OE-style suspension mounting support on Ford Windstar models

Installation Notes and Tips

Compatible With 1995-2003 Ford Windstar, front to frame. Confirm the existing bushing dimensions and mounting location before installation, and compare the old part to TD4429W to verify the correct front suspension application. Because this is a suspension bushing component, proper press-fit service and alignment checks are recommended during replacement.

Quality Assurance

Delphi validates its OE-style aftermarket parts through extreme-temperature testing and extended salt-spray exposure, along with dimensional and material analysis to support OE-to-aftermarket compatibility. Part number TD4429W reflects Delphi's standard replacement approach for front suspension service on Ford Windstar vehicles.