Delphi TD4434W Suspension Stabilizer Bar Bushing Kit - Front

Delphi TD4434W Front Stabilizer Bar Bushing Kit

The Delphi TD4434W suspension stabilizer bar bushing kit is a standard replacement for front sway bar service on select Toyota trucks and SUVs. Built with rubber construction and OE-focused dimensional analysis, it supports a precise fit for front stabilizer bar applications on Tacoma, Sequoia, and Tundra models.

Key Features

• Rubber bushing construction for front stabilizer bar mounting
• Black finish
• Standard replacement grade
• Front position application
• Measured dimensions: 2.045 in. width (51.9 mm) and 1.94 in. height (49.3 mm)
• No grease fitting included
• No mounting hardware included

OE-Style Fit and Material

Delphi applies OE-level dimensional and material analysis to help ensure proper compatibility between the original part and the aftermarket replacement. The TD4434W is built for front suspension stabilizer bar service and is tested for temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure for corrosion resistance validation. This part cross-references Dorman - Premium BSK74110PR for the same application.

Vehicle Fitment

• Fits 2022 Toyota Tacoma, Front To Frame
• Fits 2005-2021 Toyota Tacoma, Front, 27mm or 28mm sway bar diameter; with 6 lug wheels
• Fits 2001-2007 Toyota Sequoia, Front, with 27mm or 28mm bar diameter
• Fits 2002-2006 Toyota Tundra, Front, with 27mm or 28mm bar diameter
• Fits 2004 Toyota Tundra, Front, from 10/2003
• Fits 2000 Toyota Tundra, Front, to 08/2000

Common Repair Symptoms

• Front sway bar clunking or rattling over bumps
• Excessive play at the stabilizer bar mounting point
• Worn or cracked rubber bushings
• Reduced front-end stability during cornering
• Noise caused by deteriorated suspension bushings

Installation Notes

Verify sway bar diameter and vehicle configuration before installation, especially on Toyota Tacoma, Toyota Sequoia, and Toyota Tundra applications. Inspect the stabilizer bar, brackets, and surrounding suspension components for wear before replacing the bushing kit. Because mounting hardware is not included, reuse or source the required hardware separately if needed.

Quality Assurance

Delphi uses OE safety technology and aftermarket engineering experience to support consistent fit and performance in steering and suspension service parts. The TD4434W is validated through temperature and salt-spray testing to help confirm durability in demanding undercar conditions.