Delphi TD4469W Suspension Control Arm Bushing - Front Lower Rearward or Front Rearward

OE-Style Front Lower Rearward Bushing

Delphi TD4469W is a suspension control arm bushing built for front lower rearward and front rearward applications on select Toyota trucks and SUVs. It uses steel and rubber construction with a press-in mounting design to support precise suspension location and consistent ride control.

Compatible with 2000-2007 Toyota Tundra and 2001-2007 Toyota Sequoia applications, this standard replacement bushing is sized for OE-style fitment and material compatibility. Delphi applies dimensional and material analysis to help match the original part profile for the Toyota Tundra and Toyota Sequoia suspension setup.

Key Features

• Part number: TD4469W
• Suspension control arm bushing for front lower rearward and front rearward positions
• Steel and rubber construction
• Press-in mounting type
• Standard replacement grade
• Phosphate finish
• Inside diameter: 19.3
• Outside diameter: 55.29
• Length: 72.55

Detailed Description

Delphi TD4469W is engineered for Toyota suspension service where the control arm bushing must maintain alignment and isolate road vibration. The steel and rubber design supports the load demands of the front suspension while the press-in format matches the service procedure used on the original assembly. This part cross-references Toyota 48655-34010 and MOOG Chassis Products K200126 for the same application.

Delphi validates its OE-based steering and suspension parts through extreme temperature exposure below -40 degrees C and above 120 degrees C, along with extended salt-spray testing. That testing approach supports durability in demanding driving conditions and helps maintain consistent performance over time. For Toyota Tundra and Toyota Sequoia front suspension repair, TD4469W provides a direct replacement option with OE-focused dimensions and material selection.

What This Part Helps Address

• Clunking or knocking from worn front control arm bushings
• Excessive front-end movement during braking or cornering
• Uneven tire wear caused by suspension looseness
• Steering wander related to degraded bushing support
• Vibration transfer from worn rubber isolation points

Installation Notes and Tips

Fits 2001-2007 Toyota Sequoia, front lower rearward. Fits 2000-2001 Toyota Tundra, front rearward. Fits 2002-2006 Toyota Tundra, front lower rearward. Fits 2004 Toyota Tundra, front rearward. Verify the exact position on your vehicle before ordering, since this part is listed for more than one front suspension location. Press-in installation requires proper removal and installation tools, and the control arm should be inspected for wear or damage before the new bushing is installed.

Quality Assurance

Delphi uses OE engineering experience and extensive dimensional and material analysis to support aftermarket fit and function. The part is tested for temperature extremes and salt-spray exposure to help confirm durability in real-world suspension service.