Delphi TD4498W Suspension Stabilizer Bar Bushing Kit - Rear or Rear To Frame

Delphi Rear Stabilizer Bar Bushing Kit

Delphi TD4498W is a standard replacement rear stabilizer bar bushing kit built with rubber construction and OE-focused dimensional control. It is made for drivers servicing rear suspension noise, looseness, or sway bar bushing wear on select Toyota and Lexus applications.

• Rubber bushing material with black finish
• Standard replacement, regular grade
• Rear position application
• Inside diameter: 15.2 mm (0.598 in)
• Width: 27.75 mm (1.318 in)
• Outside diameter: 29.25 mm
• Height: 33.75 mm

OE-Style Fit and Construction

Delphi applies OE-level dimensional and material analysis to help ensure proper compatibility between the aftermarket part and the original suspension design. TD4498W is tested for extreme temperature exposure, from below -40 degrees C to above 120 degrees C, and is evaluated through 720 hours of salt spray exposure for durability in demanding conditions. This part cross-references Beck/Arnley 101-5574 for the same application.

Compatible With 2005-2006 Lexus ES330, rear to frame; 2002-2006 Toyota Camry, rear, USA built; and 2001-2003 Toyota Highlander, rear to frame. Use Delphi TD4498W when replacing worn rear stabilizer bar bushings on these Toyota Camry, Lexus ES330, and Toyota Highlander applications.

Common Problems This Part Addresses

• Rear suspension clunking or squeaking from worn sway bar bushings
• Excessive play at the stabilizer bar mounting point
• Rubber bushing cracking, hardening, or deformation
• Loss of rear suspension stability caused by bushing wear

Installation Notes

Verify the rear position, inside diameter, and mounting style before installation. Inspect the stabilizer bar and frame contact surfaces for wear or corrosion, and replace damaged hardware or brackets as needed during service. Confirm vehicle build details, especially the USA-built 2002-2006 Toyota Camry fitment, before ordering.

Quality Assurance

Delphi backs this suspension stabilizer bar bushing kit with OE-focused engineering and validation practices used across its aftermarket steering and suspension portfolio. TD4498W is built to meet standard replacement expectations for fit, material consistency, and durability.