Delphi TD4521W Suspension Stabilizer Bar Bushing Kit - Front or Front To Frame

Delphi Front Stabilizer Bar Bushing Kit

Restore front suspension control with the Delphi TD4521W stabilizer bar bushing kit. This standard replacement bushing is made from rubber and sized for front applications on select Chrysler, Dodge, and Plymouth vehicles, including Cirrus, Sebring, Stratus, and Breeze models.

Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, with dimensional and material analysis used to support proper part-to-vehicle matching. The TD4521W is built for front stabilizer bar service where correct bushing dimensions and material consistency matter.

• Rubber construction for front stabilizer bar mounting points
• Inside diameter: 1.25 in.
• Outside diameter: 1.94 in.
• Standard replacement grade
• Front position fitment for select Chrysler, Dodge, and Plymouth models
• Part number: TD4521W

Detailed Fitment and Application

Compatible With front stabilizer bar service on 1995-2000 Chrysler Cirrus, 1996-2000 Chrysler Sebring, 1995-2000 Dodge Stratus, and 1995-2000 Plymouth Breeze, with fitment varying by front or front-to-frame position as listed. This Delphi TD4521W bushing kit is a direct-match service part for vehicles that need a front sway bar bushing replacement to maintain proper suspension location and bar support.

This part cross-references MOOG Chassis Products K200050 for the same application.

What This Part Helps Address

• Front suspension clunking from worn stabilizer bar bushings
• Excessive sway bar movement at the frame or front mounting point
• Loose or inconsistent front-end handling feel
• Noise caused by deteriorated rubber bushings
• Fitment issues when replacing an OE-style front bushing on Chrysler Cirrus, Dodge Stratus, or Plymouth Breeze

Installation Notes and Tips

Verify the vehicle’s front stabilizer bar diameter and mounting style before installation. Compare the old bushing to the TD4521W dimensions, including the 1.25-inch inside diameter and 1.94-inch outside diameter, to confirm proper seating. Clean the mounting area before installing the new rubber bushing to help ensure correct alignment and stable contact.

Quality Assurance

Delphi subjects its OE-based aftermarket parts to extreme temperature testing from below -40 degrees C to above 120 degrees C, along with extended salt-spray exposure and dimensional/material analysis to support OE-level fit and durability expectations.