Delphi TD4533W Suspension Stabilizer Bar Bushing Kit - Front

Front Stabilizer Bar Bushing Kit

Delphi TD4533W is a front suspension stabilizer bar bushing kit built as a standard replacement for select Ford Super Duty trucks. It uses rubber construction and a 0.905 inside diameter to support proper sway bar fitment on the front suspension.

Compatible with Ford F-250 Super Duty and Ford F-350 Super Duty applications that use the listed front configurations, this Delphi TD4533W bushing kit reflects OE-focused dimensional and material analysis for accurate replacement fit.

Key Features

• Rubber bushing material for front stabilizer bar service
• 0.905 inside diameter
• Standard replacement grade
• Front position application
• OE-based dimensional and material analysis for fit accuracy
• Delphi part number TD4533W

Application Details

This front sway bar bushing kit is made for Ford Super Duty trucks with the specified front suspension configurations. Fits 2008-2016 Ford F-250 Super Duty, front, with dual rear wheels; fits 2011-2015 Ford F-250 Super Duty, front, with Monobeam Axle and dual rear wheels; fits 2008-2010 Ford F-350 Super Duty, front, with dual rear wheels; fits 2011-2013 Ford F-350 Super Duty, front, with Monobeam Axle and dual rear wheels; fits 2014 Ford F-350 Super Duty, front, with dual rear wheels; fits 2015 Ford F-350 Super Duty, front, with Monobeam Axle and dual rear wheels; fits 2016 Ford F-350 Super Duty, front, with dual rear wheels. This part cross-references Ford 7C3Z-5484-D and Moog K200883 for the same application.

Common Replacement Uses

• Front sway bar noise caused by worn rubber bushings
• Excessive play at the stabilizer bar mounting point
• Clunking or rattling from the front suspension
• Reduced stabilizer bar support on heavy-duty Ford trucks
• Replacement for deteriorated OE-style front bushings

Installation Notes

Verify the vehicle’s front suspension configuration, including dual rear wheels and Monobeam Axle notes, before ordering. Match the 0.905 inside diameter and front position to the existing stabilizer bar setup on the vehicle. Confirm fitment against the part number TD4533W and the listed Ford F-250 Super Duty and Ford F-350 Super Duty applications.

Quality Assurance

Delphi applies OE engineering standards to its aftermarket steering and suspension portfolio. These parts are tested for temperature extremes below -40 degrees C and above 120 degrees C, and are exposed to 720 hours of salt spray to evaluate durability in demanding conditions.