Delphi TD4550W Suspension Stabilizer Bar Bushing Kit - Front

Delphi Front Stabilizer Bar Bushing Kit

Delphi TD4550W is a front suspension stabilizer bar bushing kit built as a standard replacement for select Chevrolet Camaro and Pontiac Firebird applications. It uses rubber construction and a 1.259-inch inside diameter to support proper sway bar fitment on vehicles equipped with a 32mm diameter front sway bar where specified.

Delphi applies OE-focused dimensional and material analysis to help match aftermarket fitment to original equipment requirements. The brand also subjects its steering and suspension parts to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt spray exposure, to evaluate durability in demanding conditions.

• Front suspension stabilizer bar bushing kit
• Rubber material for standard replacement service
• 1.259-inch inside diameter
• Fits 1995-2002 Chevrolet Camaro, front with 32mm diameter sway bar
• Fits 1995-2002 Pontiac Firebird, front with 32mm diameter sway bar
• Fits 1993-1994 Chevrolet Camaro, front
• Fits 1993-1994 Pontiac Firebird, front

Fitment and Application Details

Compatible With Chevrolet Camaro and Pontiac Firebird front suspension applications across 1993-2002 model years, with the 1995-2002 vehicles requiring a 32mm diameter sway bar. Delphi TD4550W is a direct-fit style replacement for front stabilizer bar service on these platforms. This part cross-references MOOG Chassis Products K6672 for the same application.

Common Problems This Part Addresses

• Front sway bar movement caused by worn rubber bushings
• Clunking or rattling from the front suspension
• Excessive body roll from deteriorated stabilizer bar support
• Loose or inconsistent sway bar feel during cornering
• Noise from cracked, hardened, or compressed bushing material

Installation Notes and Tips

Confirm sway bar diameter before ordering, especially on 1995-2002 Camaro and Firebird models that use a 32mm front bar. Inspect the stabilizer bar, brackets, and surrounding suspension components for wear before installation so the new bushings seat correctly and maintain proper alignment.

Quality Assurance

Delphi uses OE engineering experience and material validation to support aftermarket steering and suspension replacement parts. TD4550W is built as a standard replacement bushing kit for front stabilizer bar service.