Delphi TD4618W Suspension Stabilizer Bar Bushing Kit - Front

Delphi TD4618W Front Stabilizer Bar Bushing Kit

Restore front suspension control with this Delphi stabilizer bar bushing kit for the 2004-2008 Suzuki Forenza, front. Built as a standard replacement, it uses rubber construction to help maintain sway bar support and reduce unwanted movement at the front axle.

Delphi TD4618W is engineered with OE-focused dimensional and material analysis for a precise aftermarket match. It is a direct choice for drivers searching for a front stabilizer bar bushing kit for Suzuki Forenza models from 2004 through 2008.

Key Features

• Brand: Delphi
• Part number: TD4618W
• Suspension stabilizer bar bushing kit for the front position
• Rubber construction with black finish
• Inside diameter: 17.0 mm (0.669 in.)
• Width: 51.0 mm (2.007 in.)
• Height: 49.0 mm (1.929 in.)
• Standard replacement grade
• No grease fitting included
• No mounting hardware included

Detailed Description

This Delphi TD4618W stabilizer bar bushing kit is made for the front suspension of the 2004-2008 Suzuki Forenza. The rubber bushing helps secure the sway bar in place, supporting consistent suspension response and reducing excess play at the bar mount. With OE-based dimensional and material analysis, this part is built to match the original fit and function expected in everyday service.

This part cross-references MOOG Chassis Products K200634 for the same application. If you are replacing worn front sway bar bushings on a Suzuki Forenza, TD4618W provides a direct-fit service part for the listed model years.

What It Helps Address

• Front-end clunking or rattling from worn stabilizer bar bushings
• Excess sway bar movement at the front suspension mount
• Loose or inconsistent steering feel caused by bushing wear
• Noise from hardened, cracked, or compressed rubber bushings
• Loss of suspension stability during cornering and road transitions

Installation Notes and Tips

Fits 2004-2008 Suzuki Forenza, front. Confirm the sway bar diameter and bushing dimensions before installation to ensure the correct match. Inspect the stabilizer bar, brackets, and surrounding suspension components for wear or corrosion during service. Because mounting hardware is not included, reuse or replace related fasteners as needed based on the vehicle condition.

Quality Assurance

Delphi applies OE-focused testing and material validation to its aftermarket steering and suspension parts. This bushing is evaluated for temperature resistance from below -40 degrees C to above 120 degrees C and exposed to extended salt-spray testing to support durability in demanding service conditions.