Delphi TD4628W Suspension Stabilizer Bar Bushing Kit - Front

Front Stabilizer Bar Bushing Kit for Mazda 626

Delphi TD4628W is a front suspension stabilizer bar bushing kit for 2000-2002 Mazda 626 models. It is a standard replacement part built around OE-focused dimensional and material analysis for consistent fit and function.

Key Features

• Standard replacement stabilizer bar bushing kit for the front suspension
• Fits 2000-2002 Mazda 626, front
• OE-based engineering for dimensional compatibility
• Tested for temperature extremes below -40 degrees C and above 120 degrees C
• Exposed to 720 hours of salt spray during validation
• Delphi TD4628W for front stabilizer bar service

Detailed Description

Delphi TD4628W is made for front stabilizer bar service on the Mazda 626 and is intended to restore proper bushing support at the sway bar mounting points. Delphi applies OE-level analysis to help ensure the aftermarket part matches the original application requirements for the 2000-2002 Mazda 626, front. This part cross-references Beck/Arnley 101-6187 for the same application.

Common Issues Addressed

• Front suspension clunking or rattling over bumps
• Excessive sway bar movement at the mounting points
• Worn or cracked stabilizer bar bushings
• Loose-feeling front-end handling on a Mazda 626
• Noise caused by deteriorated bushing material

Installation Notes and Tips

Verify the front stabilizer bar diameter and vehicle application before installation. Inspect the sway bar, brackets, and surrounding suspension components for wear or corrosion while servicing the bushings. Confirm the part number TD4628W against the vehicle’s front suspension configuration before final assembly.

Quality Assurance

Delphi validates this part through temperature cycling and extended salt-spray exposure to evaluate durability in demanding conditions. The brand’s OE-focused testing and dimensional analysis support consistent replacement quality for front suspension service on the Mazda 626.