Delphi TD4818W Suspension Stabilizer Bar Bushing Kit - Rear

Rear Stabilizer Bar Bushing Kit for Ford and Lincoln

Delphi TD4818W is a rear suspension stabilizer bar bushing kit built for OE-style replacement on select Ford Expedition and Lincoln Navigator models. It uses rubber construction and standard replacement dimensions to support proper sway bar mounting and rear suspension control.

Key Features

• Rubber bushing material with black finish
• Rear position application
• Inside diameter: 0.83 in. / 21.0 mm
• Outside diameter: 1.97 in. / 50.0 mm
• Width: 1.97 in. / 50.0 mm
• Height: 1.89 in. / 48.0 mm
• Standard replacement grade
• No grease fitting included
• No mounting hardware included

Detailed Description

Delphi TD4818W is a rear suspension stabilizer bar bushing kit engineered for OE fit and material compatibility. Delphi applies dimensional and material analysis to match the original part profile, and its OE-focused testing includes exposure to extreme temperatures and extended salt spray conditions. This part cross-references Ford 7L1Z-5493-A and MOOG Chassis Products K201487 for the same application. Use Delphi TD4818W when replacing worn rear sway bar bushings on a Ford Expedition or Lincoln Navigator and restoring consistent rear stabilizer bar support.

Vehicle Fitment

• Fits 2014-2017 Ford Expedition, rear.
• Fits 2016-2017 Lincoln Navigator, rear.
• Fits 2016-2017 Lincoln Navigator, rear, with Continuous Control Damping Suspension.
• Fits 2014-2015 Lincoln Navigator, rear, regular wagon; for vehicles with standard suspension; with self-levelling.
• Fits 2014-2015 Lincoln Navigator, rear, with self-leveling suspension.
• Fits 2007-2013 Ford Expedition, rear, regular wagon; extended wagon; for vehicles with 20 inches wheelbase.
• Fits 2007-2013 Lincoln Navigator, rear, regular wagon; extended wagon; for vehicles with 18 inches wheelbase; with rear load levelling suspension.

Common Issues This Part Can Address

• Rear sway bar bushing wear or cracking
• Clunking or rattling from the rear suspension
• Excessive play at the stabilizer bar mounting points
• Reduced rear suspension stability over bumps and turns
• Noise caused by deteriorated rubber bushings

Installation Notes and Tips

Confirm rear suspension configuration before ordering, especially on Lincoln Navigator models with self-leveling, rear load levelling, or Continuous Control Damping Suspension. Inspect the stabilizer bar and surrounding brackets for wear before installation, and replace damaged components as needed. Because mounting hardware is not included, reuse or source the required hardware separately if the original pieces are not serviceable.

Quality Assurance

Delphi uses OE-based engineering and validation methods for aftermarket steering and suspension parts. TD4818W is tested for temperature extremes and salt spray exposure to support durability in demanding road conditions.