Delphi TD4942W Suspension Stabilizer Bar Bushing Kit - Rear

Rear Stabilizer Bar Bushing Kit for Tacoma

Delphi TD4942W is a rear suspension stabilizer bar bushing kit built for 2005-2013 Toyota Tacoma applications. It uses rubber construction and OE-focused dimensional analysis to support proper fitment on the rear sway bar mounting points.

Key Features

• Rubber bushing material with black finish
• Rear position application for Toyota Tacoma
• Standard replacement grade
• Inside diameter: 24.2 mm (0.952 in.)
• Width: 43.0 mm (1.692 in.)
• Height: 39.5 mm (1.555 in.)
• No grease fitting included
• No mounting hardware included

Product Details

Delphi TD4942W is a suspension stabilizer bar bushing kit engineered for rear use on the Toyota Tacoma. Delphi applies OE-level material and dimensional analysis to aftermarket steering and suspension components, with testing that includes extreme temperature exposure and salt-spray durability evaluation. The result is a standard replacement bushing designed around the original fit and material profile for rear sway bar service. This part cross-references MOOG Chassis Products K90531 for the same application.

Common Repair Applications

• Rear sway bar bushing wear on 2005-2013 Toyota Tacoma models
• Clunking or rattling from the rear suspension area
• Excessive play at the stabilizer bar mounting points
• Rubber bushing deterioration from age, heat, or road exposure
• Restoring stable rear anti-roll bar support on Tacoma trucks

Installation Notes

Fits 2005-2013 Toyota Tacoma, rear. Verify the stabilizer bar diameter and bushing dimensions before installation. Clean the mounting surfaces thoroughly and inspect the sway bar brackets and related hardware for wear before reassembly. Because mounting hardware is not included, reuse or replace the existing fasteners as needed during service. Delphi TD4942W is also referenced by OE and aftermarket numbers including 48815-14160 and 48818-AD010.

Quality Assurance

Delphi subjects its OE-based suspension components to temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. That validation supports consistent material performance for rear Toyota Tacoma suspension service.