Delphi TD5072W Suspension Stabilizer Bar Bushing Kit - Rear To Frame

Delphi Rear Stabilizer Bar Bushing Kit

Delphi TD5072W is a standard replacement rear stabilizer bar bushing kit for select Chrysler and Dodge applications. Built with rubber and sized for the rear-to-frame mounting location, it supports proper sway bar isolation and consistent suspension response.

Use this Delphi suspension stabilizer bar bushing kit when servicing rear sway bar wear on Chrysler 200, Dodge Avenger, and Chrysler Sebring models with a 19.1mm bar diameter.

Key Features

• Rubber construction for OE-style bar isolation and noise control
• Inside diameter: 0.73 in.
• Standard replacement grade for routine suspension service
• Rear to frame position
• Delphi TD5072W engineered for OE fit and dimensional compatibility
• Tested for temperature extremes below -40°C and above 120°C
• Exposed to 720 hours of salt spray during durability validation

Detailed Description

Delphi TD5072W is a rear stabilizer bar bushing kit made for vehicles that use a 19.1mm rear sway bar. The rubber material helps isolate the bar from the frame, reducing unwanted movement and helping maintain stable handling characteristics. Delphi applies OE-level dimensional and material analysis to support accurate fitment between the replacement part and the original suspension design. This part cross-references MOOG Chassis Products K200214 for the same application.

Compatible With 2011-2014 Chrysler 200, rear to frame; 2008-2014 Dodge Avenger, rear to frame; and 2007-2010 Chrysler Sebring, rear to frame. Delphi TD5072W is a direct-fit service part for rear stabilizer bar maintenance on these platforms.

What It Helps Address

• Rear suspension clunking or squeaking from worn sway bar bushings
• Excessive stabilizer bar movement at the frame mount
• Reduced bar isolation caused by hardened or cracked rubber
• Loose-feeling rear suspension response during cornering
• Service needs on Chrysler 200, Dodge Avenger, and Chrysler Sebring rear sway bar mounts

Installation Notes and Tips

Verify the rear bar diameter is 19.1mm before installation. Confirm the rear-to-frame mounting location and compare the original bushing dimensions to Delphi TD5072W, including the 0.73 in. inside diameter. Inspect the stabilizer bar and mounting surfaces for wear, corrosion, or deformation before fitting the new bushing.

Quality Assurance

Delphi validates this suspension bushing through temperature cycling and salt-spray exposure testing to support OE-level durability in demanding conditions. The brand’s OE engineering background and dimensional analysis help ensure consistent aftermarket fitment for the listed Chrysler and Dodge applications.