Delphi TD5075W Suspension Stabilizer Bar Bushing Kit - Front

Delphi TD5075W Front Stabilizer Bar Bushing Kit

Delphi TD5075W is a front suspension stabilizer bar bushing kit built as a standard replacement for OE-style service. It uses rubber construction and a 1.1 inside diameter to support proper sway bar fitment on select vehicles, including 2006-2011 Honda Civic front applications.

Key Features

• Rubber bushing material for suspension service
• 1.1 inside diameter for OE-style sizing
• Standard replacement grade
• Front position application
• Delphi OE-focused dimensional and material analysis for fit compatibility
• Part number TD5075W for ordering and cross-reference

Application Details

Fits 2006-2011 Honda Civic, front. This Delphi TD5075W stabilizer bar bushing kit is a direct-fit suspension service part for front sway bar support on Honda Civic models in the listed years. It is also referenced by OE-style part numbers 51306-SNX-A01, 51306-SVB-A01, and K200295 for the same application.

What It Helps Address

• Front sway bar bushing wear
• Clunking or rattling from the front suspension
• Excessive play at the stabilizer bar mounting points
• Noise caused by hardened or cracked rubber bushings
• Loss of consistent front-end suspension response

Installation Notes

Verify the front stabilizer bar diameter and vehicle application before installation. Inspect the sway bar, brackets, and surrounding suspension components for wear or corrosion during service. Proper alignment of the bushing and bracket surfaces helps maintain correct fit on the Honda Civic front suspension.

Quality Assurance

Delphi applies OE-focused testing and material analysis to its aftermarket steering and suspension parts. This bushing kit is evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray testing to help confirm durability in demanding conditions.