Delphi TD5080W Suspension Stabilizer Bar Bushing Kit - Front

Front Stabilizer Bar Bushing Kit for Ford Edge and Lincoln MKX

Delphi TD5080W is a front suspension stabilizer bar bushing kit built as a standard replacement for select Ford Edge and Lincoln MKX applications. It uses rubber construction and a 1.312 inside diameter to match the OE-style fit needed for front sway bar service.

Compatible with 2007-2014 Ford Edge, front and 2007-2015 Lincoln MKX, front, this Delphi suspension bushing kit is engineered with OE dimensional and material analysis to support proper compatibility. Delphi TD5080W is also listed for 2015 Ford Edge, front, to 12/23/2014.

Key Features

• Front suspension stabilizer bar bushing kit
• Rubber material for OE-style compliance and isolation
• 1.312 inside diameter
• Standard replacement grade
• Built for front-position service on select Ford Edge and Lincoln MKX models
• Delphi TD5080W part number for accurate ordering and lookup

Detailed Product Information

Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, using dimensional and material analysis to align the replacement part with the original application. TD5080W is intended for front stabilizer bar service where the sway bar bushing must maintain proper bar location and help preserve suspension geometry. This part cross-references Ford 7T4Z-5484-A for the same application.

For fitment-based searches, this part is a direct match for front sway bar bushing replacement on 2007-2014 Ford Edge, 2007-2015 Lincoln MKX, and 2015 Ford Edge built to 12/23/2014. The Delphi TD5080W designation is useful when verifying the correct OE-style suspension stabilizer bar bushing kit before service.

Common Problems This Part Can Address

• Front sway bar movement caused by worn rubber bushings
• Clunking or rattling from the front suspension over bumps
• Excessive play at the stabilizer bar mounting point
• Reduced steering response from deteriorated bushing material
• Noise and vibration transfer from aged front stabilizer components

Installation Notes and Tips

Confirm the front stabilizer bar diameter and application before installation, since this part is specified with a 1.312 inside diameter. Inspect the sway bar, brackets, and surrounding suspension components for wear before replacing the bushing. Verify vehicle build date on 2015 Ford Edge applications, as fitment is listed only through 12/23/2014.

Use the Delphi TD5080W part number and the vehicle fitment details when ordering for Ford Edge or Lincoln MKX front suspension service. Proper alignment of the bushing and stabilizer bar during installation helps maintain correct fit and function.

Quality Assurance

Delphi subjects its OE-based suspension and steering parts to extreme temperature testing below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability in demanding conditions. The brand also uses OE dimensional and material analysis to support consistent aftermarket fitment for TD5080W.